lkml.org 
[lkml]   [2021]   [Oct]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v6 21/48] mfd: ti_am335x_tscadc: Reorder the initialization steps
Date
TI AM335X TRM [1] states that most of the configuration should be set in
the control register in the first place, before actually enabling the
hardware with the subsystem enable bit.

So far only half of the configuration was made in the first step (before
enabling the "subsystem"), which does not make really sense. Also, the
probe and the resume patch were acting differently. Let's harmonize all
this by following these steps:
1/ Configure the CLKDIV register
2/ Configure the CTRL register
3/ Configure the idle configuration
4/ Really enable the device by rewriting the CTRL register with the
subsystem enable bit set.

[1] https://www.ti.com/lit/pdf/spruh73

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Reviewed-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
---
drivers/mfd/ti_am335x_tscadc.c | 11 +++++------
1 file changed, 5 insertions(+), 6 deletions(-)

diff --git a/drivers/mfd/ti_am335x_tscadc.c b/drivers/mfd/ti_am335x_tscadc.c
index 82cee764acc8..45f80834cabd 100644
--- a/drivers/mfd/ti_am335x_tscadc.c
+++ b/drivers/mfd/ti_am335x_tscadc.c
@@ -219,8 +219,6 @@ static int ti_tscadc_probe(struct platform_device *pdev)

/* Set the control register bits */
ctrl = CNTRLREG_STEPCONFIGWRT | CNTRLREG_STEPID;
- regmap_write(tscadc->regmap, REG_CTRL, ctrl);
-
if (tsc_wires > 0) {
tscadc->tsc_wires = tsc_wires;
if (tsc_wires == 5)
@@ -228,6 +226,7 @@ static int ti_tscadc_probe(struct platform_device *pdev)
else
ctrl |= CNTRLREG_4WIRE | CNTRLREG_TSCENB;
}
+ regmap_write(tscadc->regmap, REG_CTRL, ctrl);

tscadc_idle_config(tscadc);

@@ -313,9 +312,9 @@ static int __maybe_unused tscadc_resume(struct device *dev)
pm_runtime_get_sync(dev);

/* context restore */
- ctrl = CNTRLREG_STEPCONFIGWRT | CNTRLREG_STEPID;
- regmap_write(tscadc->regmap, REG_CTRL, ctrl);
+ regmap_write(tscadc->regmap, REG_CLKDIV, tscadc->clk_div);

+ ctrl = CNTRLREG_STEPCONFIGWRT | CNTRLREG_STEPID;
if (tscadc->tsc_wires > 0) {
if (tscadc->tsc_wires == 5)
ctrl |= CNTRLREG_5WIRE | CNTRLREG_TSCENB;
@@ -323,13 +322,13 @@ static int __maybe_unused tscadc_resume(struct device *dev)
ctrl |= CNTRLREG_4WIRE | CNTRLREG_TSCENB;
}

+ regmap_write(tscadc->regmap, REG_CTRL, ctrl);
+
tscadc_idle_config(tscadc);

ctrl |= CNTRLREG_TSCSSENB;
regmap_write(tscadc->regmap, REG_CTRL, ctrl);

- regmap_write(tscadc->regmap, REG_CLKDIV, tscadc->clk_div);
-
return 0;
}

--
2.27.0
\
 
 \ /
  Last update: 2021-10-15 10:17    [W:0.173 / U:0.048 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site