lkml.org 
[lkml]   [2021]   [Oct]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH 1/2] arm/arm64: dts: Enable 2.5G Ethernet port on CN9130-CRB
Date
Hello Chris,

> Enable the 2.5G Ethernet port by setting the status to "okay" and the
> phy-mode to "2500base-x" on the cn9130-crb boards. Tested on a
> CN9130-CRB-A.
>
> Signed-off-by: Chris Packham <chris.packham@alliedtelesis.co.nz>

As I am not sure that next week the pull request will be accepted when
you will send the v2 for the second patch, I already applied the one on
mvebu/dt64

Thanks,

Gregory


> ---
>
> The Marvell SDK adds 2500base-t and uses it in the equivalent dtsi but
> looking at the documentation for both the SoC and the PHY I think
> 2500base-x is correct for the system interface (the line side is
> 2500base-t).
>
> arch/arm64/boot/dts/marvell/cn9130-crb.dtsi | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/arch/arm64/boot/dts/marvell/cn9130-crb.dtsi b/arch/arm64/boot/dts/marvell/cn9130-crb.dtsi
> index 505ae69289f6..e7918f325646 100644
> --- a/arch/arm64/boot/dts/marvell/cn9130-crb.dtsi
> +++ b/arch/arm64/boot/dts/marvell/cn9130-crb.dtsi
> @@ -214,8 +214,8 @@ &cp0_eth1 {
> };
>
> &cp0_eth2 {
> - /* This port uses "2500base-t" phy-mode */
> - status = "disabled";
> + status = "okay";
> + phy-mode = "2500base-x";
> phy = <&nbaset_phy0>;
> phys = <&cp0_comphy5 2>;
> };
> --
> 2.33.0
>

--
Gregory Clement, Bootlin
Embedded Linux and Kernel engineering
http://bootlin.com

\
 
 \ /
  Last update: 2021-10-13 16:52    [W:0.100 / U:0.164 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site