Messages in this thread | | | Date | Thu, 7 Jan 2021 09:43:14 +0100 | From | Wilken Gottwalt <> | Subject | Re: [PATCH v5 2/2] hwspinlock: add sun6i hardware spinlock support |
| |
On Wed, 6 Jan 2021 11:15:42 +0100 Maxime Ripard <maxime@cerno.tech> wrote:
> On Wed, Dec 23, 2020 at 12:35:10PM +0100, Wilken Gottwalt wrote: > > Adds the sun6i_hwspinlock driver for the hardware spinlock unit found in > > most of the sun6i compatible SoCs. > > > > This unit provides at least 32 spinlocks in hardware. The implementation > > supports 32, 64, 128 or 256 32bit registers. A lock can be taken by > > reading a register and released by writing a 0 to it. This driver > > supports all 4 spinlock setups, but for now only the first setup (32 > > locks) seem to exist in available devices. This spinlock unit is shared > > between all ARM cores and the embedded companion core. All of them can > > take/release a lock with a single cycle operation. It can be used to > > sync access to devices shared by the ARM cores and the companion core. > > > > There are two ways to check if a lock is taken. The first way is to read > > a lock. If a 0 is returned, the lock was free and is taken now. If an 1 > > is returned, the caller has to try again. Which means the lock is taken. > > The second way is to read a 32bit wide status register where every bit > > represents one of the 32 first locks. According to the datasheets this > > status register supports only the 32 first locks. This is the reason the > > first way (lock read/write) approach is used to be able to cover all 256 > > locks in future devices. The driver also reports the amount of supported > > locks via debugfs. > > > > Signed-off-by: Wilken Gottwalt <wilken.gottwalt@posteo.net> > > Reviewed-by: Maxime Ripard <mripard@kernel.org>
Does it mean the driver is okay and I only need to fix the bindings documentation? If so, would you prefer an updated patch set or only the documentation patch in a new version?
> Thanks! > Maxime
| |