lkml.org 
[lkml]   [2020]   [Sep]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/9] Documentation: gpio: add documentation for gpio-mockup
Date
From: Bartosz Golaszewski <bgolaszewski@baylibre.com>

There's some documentation for gpio-mockup's debugfs interface in the
driver's source but it's not much. Add proper documentation for this
testing module.

Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
---
.../admin-guide/gpio/gpio-mockup.rst | 50 +++++++++++++++++++
1 file changed, 50 insertions(+)
create mode 100644 Documentation/admin-guide/gpio/gpio-mockup.rst

diff --git a/Documentation/admin-guide/gpio/gpio-mockup.rst b/Documentation/admin-guide/gpio/gpio-mockup.rst
new file mode 100644
index 000000000000..9fa1618b3adc
--- /dev/null
+++ b/Documentation/admin-guide/gpio/gpio-mockup.rst
@@ -0,0 +1,50 @@
+.. SPDX-License-Identifier: GPL-2.0-only
+
+GPIO Testing Driver
+===================
+
+The GPIO Testing Driver (gpio-mockup) provides a way to create simulated GPIO
+chips for testing purposes. The lines exposed by these chips can be accessed
+using the standard GPIO character device interface as well as manipulated
+using the dedicated debugfs directory structure.
+
+Creating simulated chips using module params
+--------------------------------------------
+
+When loading the gpio-mockup driver a number of parameters can be passed to the
+module.
+
+ gpio_mockup_ranges
+
+ This parameter takes an argument in the form of an array of integer
+ pairs. Each pair defines the base GPIO number (if any) and the number
+ of lines exposed by the chip. If the base GPIO is -1, the gpiolib
+ will assign it automatically.
+
+ Example: gpio_mockup_ranges=-1,8,-1,16,405,4
+
+ The line above creates three chips. The first one will expose 8 lines,
+ the second 16 and the third 4. The base GPIO for the third chip is set
+ to 405 while for two first chips it will be assigned automatically.
+
+ gpio_named_lines
+
+ This parameter doesn't take any arguments. It lets the driver know that
+ GPIO lines exposed by it should be named.
+
+ The name format is: gpio-mockup-X-Y where X is mockup chip's ID
+ and Y is the line offset.
+
+Manipulating simulated lines
+----------------------------
+
+Each mockup chip creates its own subdirectory in /sys/kernel/debug/gpio-mockup/.
+The directory is named after the chip's label. A symlink is also created, named
+after the chip's name, which points to the label directory.
+
+Inside each subdirectory, there's a separate attribute for each GPIO line. The
+name of the attribute represents the line's offset in the chip.
+
+Reading from a line attribute returns the current value. Writing to it (0 or 1)
+changes the configuration of the simulated pull-up/pull-down resistor
+(1 - pull-up, 0 - pull-down).
--
2.26.1
\
 
 \ /
  Last update: 2020-09-24 13:39    [W:0.089 / U:0.432 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site