Messages in this thread | | | Date | Fri, 18 Sep 2020 21:24:34 +0200 | From | Andrew Lunn <> | Subject | Re: [PATCH net-next v2 1/3] ethtool: Add 100base-FX link mode entries |
| |
On Fri, Sep 18, 2020 at 02:14:51PM -0500, Dan Murphy wrote: > Add entries for the 100base-FX full and half duplex supported modes. > > $ ethtool eth0 > Supported ports: [ FIBRE ] > Supported link modes: 100baseFX/Half 100baseFX/Full > Supported pause frame use: Symmetric Receive-only > Supports auto-negotiation: No > Supported FEC modes: Not reported > Advertised link modes: 100baseFX/Half 100baseFX/Full > Advertised pause frame use: No > Advertised auto-negotiation: No > Advertised FEC modes: Not reported > Speed: 100Mb/s > Duplex: Full > Auto-negotiation: off > Port: MII > PHYAD: 1 > Transceiver: external > Supports Wake-on: gs > Wake-on: d > SecureOn password: 00:00:00:00:00:00 > Current message level: 0x00000000 (0) > > Link detected: yes > > Signed-off-by: Dan Murphy <dmurphy@ti.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Andrew
| |