lkml.org 
[lkml]   [2020]   [Sep]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH 0/5] usb: dwc-meson-g12a: Add support for USB on S400 board
Date
Neil Armstrong <narmstrong@baylibre.com> writes:

> The Amlogic AXG is close from the GXL Glue but with a single OTG PHY.

minor grammar nit: s/close from/close to/ (also in patches 2 & 3).
Otherwise..

Reviewed-by: Kevin Hilman <khilman@baylibre.com>

Kevin



> It needs the same init sequence as GXL & GXM, but it seems it doesn't need
> the host disconnect bit.
>
> The Glue driver reuses the already implemented GXL & GXM work.
>
> The USB2 PHY driver needs a slight tweak to keep the OTG detection working.
>
> Neil Armstrong (5):
> phy: amlogic: phy-meson-gxl-usb2: keep ID pull-up even in Host mode
> dt-bindings: usb: amlogic,meson-g12a-usb-ctrl: add the Amlogic AXG
> Families USB Glue Bindings
> usb: dwc-meson-g12a: Add support for USB on AXG SoCs
> arm64: dts: meson-axg: add USB nodes
> arm64: dts: meson-axg-s400: enable USB OTG
>
> .../usb/amlogic,meson-g12a-usb-ctrl.yaml | 22 +++++++-
> .../arm64/boot/dts/amlogic/meson-axg-s400.dts | 10 ++++
> arch/arm64/boot/dts/amlogic/meson-axg.dtsi | 51 +++++++++++++++++++
> drivers/phy/amlogic/phy-meson-gxl-usb2.c | 3 +-
> drivers/usb/dwc3/dwc3-meson-g12a.c | 17 +++++++
> 5 files changed, 101 insertions(+), 2 deletions(-)
>
> --
> 2.22.0

\
 
 \ /
  Last update: 2020-09-14 19:59    [W:0.141 / U:0.384 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site