lkml.org 
[lkml]   [2020]   [Aug]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v2] i2c: iproc: fix race between client unreg and isr
Date
On 8/7/2020, Florian Fainelli wrote:
> > When i2c client unregisters, synchronize irq before setting
> > iproc_i2c->slave to NULL.
> >
> > (1) disable_irq()
> > (2) Mask event enable bits in control reg
> > (3) Erase slave address (avoid further writes to rx fifo)
> > (4) Flush tx and rx FIFOs
> > (5) Clear pending event (interrupt) bits in status reg
> > (6) enable_irq()
> > (7) Set client pointer to NULL
> >
>
> > @@ -1091,6 +1091,17 @@ static int bcm_iproc_i2c_unreg_slave(struct i2c_client *slave)
> > tmp &= ~BIT(S_CFG_EN_NIC_SMB_ADDR3_SHIFT);
> > iproc_i2c_wr_reg(iproc_i2c, S_CFG_SMBUS_ADDR_OFFSET, tmp);
> >
> > + /* flush TX/RX FIFOs */
> > + tmp = (BIT(S_FIFO_RX_FLUSH_SHIFT) | BIT(S_FIFO_TX_FLUSH_SHIFT));
> > + iproc_i2c_wr_reg(iproc_i2c, S_FIFO_CTRL_OFFSET, tmp);
> > +
> > + /* clear all pending slave interrupts */
> > + iproc_i2c_wr_reg(iproc_i2c, IS_OFFSET, ISR_MASK_SLAVE);
> > +
> > + enable_irq(iproc_i2c->irq);
> > +
> > + iproc_i2c->slave = NULL;
>
> There is nothing that checks on iproc_i2c->slave being valid within the
> interrupt handler, we assume that the pointer is valid which is fin,
> however non functional it may be, it may feel more natural to move the
> assignment before the enable_irq()?

As far as the teardown sequence ensures no more interrupts arrive after
enable_irq() and they are enabled only after setting pointer during
client register(); checking for NULL in ISR isn't necessary.

If The teardown sequence doesn't guarantee quiescing of interrupts,
setting NULL before or after enable_irq() is equally vulnerable.

Dhananjay

\
 
 \ /
  Last update: 2020-08-08 05:56    [W:0.043 / U:0.424 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site