Messages in this thread | | | Date | Fri, 07 Aug 2020 17:24:11 -0700 (PDT) | Subject | Re: [PATCH v5 0/2] Add 802.1AD protocol support for dsa switch and ocelot driver | From | David Miller <> |
| |
From: hongbo.wang@nxp.com Date: Fri, 7 Aug 2020 19:13:47 +0800
> From: "hongbo.wang" <hongbo.wang@nxp.com> > > 1. the patch 0001* is for setting single port into 802.1AD(QinQ) mode, > before this patch, the function dsa_slave_vlan_rx_add_vid didn't pass > the parameter "proto" to next port level, so switch's port can't get > parameter "proto" > after applying this patch, the following command can be supported: > ip link set br0 type bridge vlan_protocol 802.1ad > ip link add link swp1 name swp1.100 type vlan protocol 802.1ad id 100 > > 2. the patch 0002* is for setting QinQ related registers in ocelot > switch driver, after applying this patch, the switch(VSC99599)'s port can > enable or disable QinQ mode. > > 3. Version log > v5: > a. add devlink to enable qinq_mode of ocelot's single port > b. modify br_switchdev_port_vlan_add to pass bridge's vlan_proto to port driver > c. enable NETIF_F_HW_VLAN_STAG_FILTER in ocelot driver > v4: > a. modify slave.c to support "ip set br0 type bridge vlan_protocol 802.1ad" > b. modify ocelot.c, if enable QinQ, set VLAN_AWARE_ENA and VLAN_POP_CNT per > port when vlan_filter=1 > v3: combine two patches to one post
Please defer new feature changes, like this, until the net-next tree is open again. It is closed right now.
Thank you.
| |