Messages in this thread | | | Subject | Re: [PATCH v8 2/3] drm: bridge: Add support for Cadence MHDP DPI/DP bridge | From | Tomi Valkeinen <> | Date | Fri, 7 Aug 2020 12:38:54 +0300 |
| |
Hi Swapnil,
On 06/08/2020 14:34, Swapnil Jakhade wrote: > Add a new DRM bridge driver for Cadence MHDP DPTX IP used in TI J721e SoC. > MHDP DPTX IP is the component that complies with VESA DisplayPort (DP) and > embedded Display Port (eDP) standards. It integrates uCPU running the > embedded Firmware (FW) interfaced over APB interface. > > Basically, it takes a DPI stream as input and outputs it encoded in DP > format. Currently, it supports only SST mode. > > Co-developed-by: Tomi Valkeinen <tomi.valkeinen@ti.com> > Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com> > Co-developed-by: Jyri Sarha <jsarha@ti.com> > Signed-off-by: Jyri Sarha <jsarha@ti.com> > Signed-off-by: Quentin Schulz <quentin.schulz@free-electrons.com> > Signed-off-by: Yuti Amonkar <yamonkar@cadence.com> > Signed-off-by: Swapnil Jakhade <sjakhade@cadence.com> > ---
<snip>
> + mhdp_state = to_cdns_mhdp_bridge_state(new_state); > + > + mhdp_state->current_mode = drm_mode_duplicate(bridge->dev, mode); > + drm_mode_set_name(mhdp_state->current_mode); > +
current_mode is never freed, so this leaks memory.
Tomi
-- Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki. Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
| |