lkml.org 
[lkml]   [2020]   [Aug]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/3] backlight: pwm_bl: Artificially add 0% during interpolation
On Mon, Jul 20, 2020 at 09:25:21PM -0700, Alexandru Stan wrote:
> Some displays need the low end of the curve cropped in order to make
> them happy. In that case we still want to have the 0% point, even though
> anything between 0% and 5%(example) would be skipped.
>
> Signed-off-by: Alexandru Stan <amstan@chromium.org>
> ---
>
> drivers/video/backlight/pwm_bl.c | 8 ++++++++
> 1 file changed, 8 insertions(+)
>
> diff --git a/drivers/video/backlight/pwm_bl.c b/drivers/video/backlight/pwm_bl.c
> index 5193a72305a2..b24711ddf504 100644
> --- a/drivers/video/backlight/pwm_bl.c
> +++ b/drivers/video/backlight/pwm_bl.c
> @@ -349,6 +349,14 @@ static int pwm_backlight_parse_dt(struct device *dev,
> /* Fill in the last point, since no line starts here. */
> table[x2] = y2;
>
> + /*
> + * If we don't start at 0 yet we're increasing, assume
> + * the dts wanted to crop the low end of the range, so
> + * insert a 0 to provide a display off mode.
> + */
> + if (table[0] > 0 && table[0] < table[num_levels - 1])
> + table[0] = 0;

Isn't that what the enable/disable switch in backlights are for? There's
lots of backligh drivers (mostly the firmware variety) where setting the
backlight to 0 does not shut it off, it's just the lowest setting.

But I've not been involved in the details of these discussions.
-Daniel

> +
> /*
> * As we use interpolation lets remove current
> * brightness levels table and replace for the
> --
> 2.27.0
>
> _______________________________________________
> dri-devel mailing list
> dri-devel@lists.freedesktop.org
> https://lists.freedesktop.org/mailman/listinfo/dri-devel

--
Daniel Vetter
Software Engineer, Intel Corporation
http://blog.ffwll.ch

\
 
 \ /
  Last update: 2020-08-07 10:22    [W:0.083 / U:0.756 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site