lkml.org 
[lkml]   [2020]   [Aug]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3] mm: Fix kthread_use_mm() vs TLB invalidate
Excerpts from Nicholas Piggin's message of August 28, 2020 1:26 pm:
> Excerpts from peterz@infradead.org's message of August 21, 2020 11:04 pm:
>> On Fri, Aug 21, 2020 at 11:09:51AM +0530, Aneesh Kumar K.V wrote:
>>> Peter Zijlstra <peterz@infradead.org> writes:
>>>
>>> > For SMP systems using IPI based TLB invalidation, looking at
>>> > current->active_mm is entirely reasonable. This then presents the
>>> > following race condition:
>>> >
>>> >
>>> > CPU0 CPU1
>>> >
>>> > flush_tlb_mm(mm) use_mm(mm)
>>> > <send-IPI>
>>> > tsk->active_mm = mm;
>>> > <IPI>
>>> > if (tsk->active_mm == mm)
>>> > // flush TLBs
>>> > </IPI>
>>> > switch_mm(old_mm,mm,tsk);
>>> >
>>> >
>>> > Where it is possible the IPI flushed the TLBs for @old_mm, not @mm,
>>> > because the IPI lands before we actually switched.
>>> >
>>> > Avoid this by disabling IRQs across changing ->active_mm and
>>> > switch_mm().
>>> >
>>> > [ There are all sorts of reasons this might be harmless for various
>>> > architecture specific reasons, but best not leave the door open at
>>> > all. ]
>>>
>>>
>>> Do we have similar race with exec_mmap()? I am looking at exec_mmap()
>>> runnning parallel to do_exit_flush_lazy_tlb(). We can get
>>>
>>> if (current->active_mm == mm) {
>>>
>>> true and if we don't disable irq around updating tsk->mm/active_mm we
>>> can end up doing mmdrop on wrong mm?
>>
>> exec_mmap() is called after de_thread(), there should not be any mm
>> specific invalidations around I think.
>>
>> Then again, CLONE_VM without CLONE_THREAD might still be possible, so
>> yeah, we probably want IRQs disabled there too, just for consistency and
>> general paranoia if nothing else.
>
> The problem is probably not this TLB flushing race, but I think there
> is a lazy tlb race.

Hmm, is it possible for something to be holding the mm_users when we
exec? That could actually make it a problem for TLB flushing too.

Thanks,
Nick

\
 
 \ /
  Last update: 2020-08-28 08:56    [W:0.930 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site