lkml.org 
[lkml]   [2020]   [Aug]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 2/2] leds: Add an optional property named 'sdb-gpios'
On Sat, Aug 08, 2020 at 11:37:31AM +0800, Grant Feng wrote:
> The chip enters hardware shutdown when the SDB pin is pulled low.
> The chip releases hardware shutdown when the SDB pin is pulled high.
>
> Signed-off-by: Grant Feng <von81@163.com>
> ---
> Documentation/devicetree/bindings/leds/leds-is31fl319x.txt | 2 ++
> 1 file changed, 2 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/leds/leds-is31fl319x.txt b/Documentation/devicetree/bindings/leds/leds-is31fl319x.txt
> index fc2603484544..e8bef4be57dc 100644
> --- a/Documentation/devicetree/bindings/leds/leds-is31fl319x.txt
> +++ b/Documentation/devicetree/bindings/leds/leds-is31fl319x.txt
> @@ -16,6 +16,7 @@ Optional properties:
> - audio-gain-db : audio gain selection for external analog modulation input.
> Valid values: 0 - 21, step by 3 (rounded down)
> Default: 0
> +- sdb-gpios : Specifier of the GPIO connected to SDB pin.

We normally use 'shutdown-gpios' for a shutdown GPIO.

>
> Each led is represented as a sub-node of the issi,is31fl319x device.
> There can be less leds subnodes than the chip can support but not more.
> @@ -44,6 +45,7 @@ fancy_leds: leds@65 {
> #address-cells = <1>;
> #size-cells = <0>;
> reg = <0x65>;
> + sdb-gpios = <&gpio0 11 GPIO_ACTIVE_HIGH>;
>
> red_aux: led@1 {
> label = "red:aux";
> --
> 2.17.1
>
>

\
 
 \ /
  Last update: 2020-08-25 00:22    [W:0.049 / U:0.172 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site