[lkml]   [2020]   [Aug]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[RFC PATCH 03/17] bcma: Drop uses of pci_read_config_*() return value
The return value of pci_read_config_*() may not indicate a device error.
However, the value read by these functions is more likely to indicate
this kind of error. This presents two overlapping ways of reporting
errors and complicates error checking.

It is possible to move to one single way of checking for error if the
dependency on the return value of these functions is removed, then it
can later be made to return void.

Remove all uses of the return value of pci_read_config_*().
Check the actual value read for ~0. In this case, ~0 is an invalid
value thus it indicates some kind of error.

Suggested-by: Bjorn Helgaas <>
Signed-off-by: Saheed O. Bolarinwa <>
drivers/bcma/host_pci.c | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/bcma/host_pci.c b/drivers/bcma/host_pci.c
index 69c10a7b7c61..912d5311a444 100644
--- a/drivers/bcma/host_pci.c
+++ b/drivers/bcma/host_pci.c
@@ -372,9 +372,11 @@ int bcma_host_pci_irq_ctl(struct bcma_bus *bus, struct bcma_device *core,

pdev = bus->host_pci;

- err = pci_read_config_dword(pdev, BCMA_PCI_IRQMASK, &tmp);
- if (err)
+ pci_read_config_dword(pdev, BCMA_PCI_IRQMASK, &tmp);
+ if (tmp == (u32)~0) {
+ err = -ENODEV;
goto out;
+ }

coremask = BIT(core->core_index) << 8;
if (enable)
 \ /
  Last update: 2020-08-01 14:25    [W:1.402 / U:0.184 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site