lkml.org 
[lkml]   [2020]   [Jul]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [RFC PATCH] usb: dwc3: fix maximum_speed check for usb2.0-only core
Date
Hi,

Chunfeng Yun wrote:
> The maximum_speed will be USB_SPEED_SUPER_PLUS, but the
> maximum_speed check for usb2.0-only core doesn't consider it,
> so fix it, and move the ckeck into dwc3_check_params().
>
> Signed-off-by: Chunfeng Yun <chunfeng.yun@mediatek.com>
> ---
> Note:
>
> When I look at the code, find that this may be a problem, but no
> platform to test it.
> ---
> drivers/usb/dwc3/core.c | 14 +++++++-------
> 1 file changed, 7 insertions(+), 7 deletions(-)
>
> diff --git a/drivers/usb/dwc3/core.c b/drivers/usb/dwc3/core.c
> index 25c686a7..ffd5ab3 100644
> --- a/drivers/usb/dwc3/core.c
> +++ b/drivers/usb/dwc3/core.c
> @@ -930,13 +930,6 @@ static int dwc3_core_init(struct dwc3 *dwc)
> */
> dwc3_writel(dwc->regs, DWC3_GUID, LINUX_VERSION_CODE);
>
> - /* Handle USB2.0-only core configuration */
> - if (DWC3_GHWPARAMS3_SSPHY_IFC(dwc->hwparams.hwparams3) ==
> - DWC3_GHWPARAMS3_SSPHY_IFC_DIS) {
> - if (dwc->maximum_speed == USB_SPEED_SUPER)
> - dwc->maximum_speed = USB_SPEED_HIGH;
> - }
> -
> ret = dwc3_phy_setup(dwc);
> if (ret)
> goto err0;
> @@ -1426,6 +1419,13 @@ static void dwc3_check_params(struct dwc3 *dwc)
>
> break;
> }
> +
> + /* Handle USB2.0-only core configuration */
> + if (DWC3_GHWPARAMS3_SSPHY_IFC(dwc->hwparams.hwparams3) ==
> + DWC3_GHWPARAMS3_SSPHY_IFC_DIS) {
> + if (dwc->maximum_speed > USB_SPEED_HIGH)
> + dwc->maximum_speed = USB_SPEED_HIGH;
> + }
> }
>
> static int dwc3_probe(struct platform_device *pdev)

Actually, the dwc->maximum_speed captures the maximum speed device
property value. It maybe be set based on the phy's capability if there's
no property specifying it (i.e. maximum_speed is USB_SPEED_UNKNOWN).

So, this code should be removed. The fix should be in the check of
dwc3_check_params(). If maximum_speed = USB_SPEED_UNKNOWN and the phy's
capability is only up to highspeed, then set the maximum_speed to
highspeed only.

Thanks,
Thinh
\
 
 \ /
  Last update: 2020-07-10 00:18    [W:0.243 / U:0.036 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site