lkml.org 
[lkml]   [2020]   [Jul]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v3] usb: dwc3: Add support for VBUS power control
From
Date

Met vriendelijke groet / kind regards,

Mike Looijmans
System Expert


TOPIC Embedded Products B.V.
Materiaalweg 4, 5681 RJ Best
The Netherlands

T: +31 (0) 499 33 69 69
E: mike.looijmans@topicproducts.com
W: www.topicproducts.com

Please consider the environment before printing this e-mail
On 27-07-2020 13:53, Mark Brown wrote:
> On Mon, Jul 27, 2020 at 01:50:26PM +0200, Mike Looijmans wrote:
>>
>> Met vriendelijke groet / kind regards,
>>
>> Mike Looijmans
>> System Expert
>
> You probably want to remove your signature when replying to the list...
>
>> On 27-07-2020 12:23, Mark Brown wrote:
>>> On Sun, Jul 26, 2020 at 09:10:39AM +0200, Mike Looijmans wrote:
>
>>>> It's the 5V VBUS power for the USB "plug" that's being controlled here. It
>>>> must turned on when the controller is in "host" mode. Some boards arrange
>>>> this in hardware through the PHY, and some just don't have any control at
>>>> all and have it permanently on or off. On a board where the 5V is controlled
>>>> using a GPIO line or an I2C chip, this patch is required to make it work.
>
>>> That sounds like the driver should not be using _get_optional() then.
>
>> Making it mandatory would break most (read: all except Topic's) existing
>> boards as they won't have it in their devicetree. I'm perfectly okay with
>> that, but others might disagree.
>
> No, it wouldn't break them at all - they'd get a dummy regulator
> provided.
>

Ah, so *not* using _get_optional will yield the behaviour that I'd want. I'll
test and make a v4 patch.

\
 
 \ /
  Last update: 2020-07-28 09:30    [W:0.238 / U:0.140 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site