lkml.org 
[lkml]   [2020]   [Jul]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2] i2c: i2c-qcom-geni: Fix DMA transfer race
On Thu, Jul 23, 2020 at 09:56:34PM +0200, Wolfram Sang wrote:
> On Wed, Jul 22, 2020 at 03:00:21PM -0700, Douglas Anderson wrote:
> > When I have KASAN enabled on my kernel and I start stressing the
> > touchscreen my system tends to hang. The touchscreen is one of the
> > only things that does a lot of big i2c transfers and ends up hitting
> > the DMA paths in the geni i2c driver. It appears that KASAN adds
> > enough delay in my system to tickle a race condition in the DMA setup
> > code.
> >
> > When the system hangs, I found that it was running the geni_i2c_irq()
> > over and over again. It had these:
> >
> > m_stat = 0x04000080
> > rx_st = 0x30000011
> > dm_tx_st = 0x00000000
> > dm_rx_st = 0x00000000
> > dma = 0x00000001
> >
> > Notably we're in DMA mode but are getting M_RX_IRQ_EN and
> > M_RX_FIFO_WATERMARK_EN over and over again.
> >
> > Putting some traces in geni_i2c_rx_one_msg() showed that when we
> > failed we were getting to the start of geni_i2c_rx_one_msg() but were
> > never executing geni_se_rx_dma_prep().
> >
> > I believe that the problem here is that we are starting the geni
> > command before we run geni_se_rx_dma_prep(). If a transfer makes it
> > far enough before we do that then we get into the state I have
> > observed. Let's change the order, which seems to work fine.
> >
> > Although problems were seen on the RX path, code inspection suggests
> > that the TX should be changed too. Change it as well.
> >
> > Fixes: 37692de5d523 ("i2c: i2c-qcom-geni: Add bus driver for the Qualcomm GENI I2C controller")
> > Signed-off-by: Douglas Anderson <dianders@chromium.org>
> > Tested-by: Sai Prakash Ranjan <saiprakash.ranjan@codeaurora.org>
> > Reviewed-by: Akash Asthana <akashast@codeaurora.org>
>
> Applied to for-current, thanks!

Glad we got this sorted. I just wondered that Alok wasn't part of the
discussion. Is he still interested in maintaining the driver? Also
because there is an unprocessed patch left for this driver:

http://patchwork.ozlabs.org/project/linux-i2c/patch/20191103212204.13606-1-colin.king@canonical.com/

[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2020-07-26 14:49    [W:0.117 / U:0.120 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site