lkml.org 
[lkml]   [2020]   [Jul]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2 2/2] i2c: iproc: add slave pec support
On Fri, Jul 24, 2020 at 1:50 AM Wolfram Sang <wsa@kernel.org> wrote:
>
>
> > + /* Enable partial slave HW PEC support if requested by the client */
> > + iproc_i2c->en_s_pec = !!(slave->flags & I2C_CLIENT_PEC);
> > + if (iproc_i2c->en_s_pec)
> > + dev_info(iproc_i2c->device, "Enable PEC\n");
>
> Where do you set the I2C_CLIENT_PEC flag for the slave? Is your backend
> code publicly available?

I2C_CLIENT_PEC should be set by backend before calling i2c_slave_register() ie

client->flags |= I2C_CLIENT_PEC;
ret = i2c_slave_register(client, i2c_slave_eeprom_slave_cb);
------
------
------

My backend code is not yet publicly available.

>
> I may need a second thought here, but I am not sure I2C_CLIENT_PEC is
> the right way to enable PEC. Isn't it actually depending on the backend
> if PEC is needed? I.e. is the backend an I2C device or an SMBus device?
>
Yes, it depends on the backend. If backend is SMBUS device and
supports PEC then it should set client->flags |= I2C_CLIENT_PEC,
before calling i2c_slave_register(), so that the slave bus driver will
enable PEC in device.

Best regards,
Rayagonda

\
 
 \ /
  Last update: 2020-07-24 11:38    [W:0.116 / U:0.064 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site