lkml.org 
[lkml]   [2020]   [Jul]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[tip: timers/core] clocksource/drivers/nomadik-mtu: Handle 32kHz clock
The following commit has been merged into the timers/core branch of tip:

Commit-ID: aaea0b83458cdb3467e27deb7403b4403152dbd6
Gitweb: https://git.kernel.org/tip/aaea0b83458cdb3467e27deb7403b4403152dbd6
Author: Linus Walleij <linus.walleij@linaro.org>
AuthorDate: Mon, 29 Jun 2020 00:01:53 +02:00
Committer: Daniel Lezcano <daniel.lezcano@linaro.org>
CommitterDate: Thu, 23 Jul 2020 16:57:43 +02:00

clocksource/drivers/nomadik-mtu: Handle 32kHz clock

It happens on the U8420-sysclk Ux500 PRCMU firmware
variant that the MTU clock is just 32768 Hz, and in this
mode the minimum ticks is 5 rather than two.

I think this is simply so that there is enough time
for the register write to propagate through the
interconnect to the registers.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Link: https://lore.kernel.org/r/20200628220153.67011-1-linus.walleij@linaro.org
---
drivers/clocksource/nomadik-mtu.c | 11 +++++++++--
1 file changed, 9 insertions(+), 2 deletions(-)

diff --git a/drivers/clocksource/nomadik-mtu.c b/drivers/clocksource/nomadik-mtu.c
index f49a631..1cf3304 100644
--- a/drivers/clocksource/nomadik-mtu.c
+++ b/drivers/clocksource/nomadik-mtu.c
@@ -186,6 +186,7 @@ static int __init nmdk_timer_init(void __iomem *base, int irq,
{
unsigned long rate;
int ret;
+ int min_ticks;

mtu_base = base;

@@ -194,7 +195,8 @@ static int __init nmdk_timer_init(void __iomem *base, int irq,

/*
* Tick rate is 2.4MHz for Nomadik and 2.4Mhz, 100MHz or 133 MHz
- * for ux500.
+ * for ux500, and in one specific Ux500 case 32768 Hz.
+ *
* Use a divide-by-16 counter if the tick rate is more than 32MHz.
* At 32 MHz, the timer (with 32 bit counter) can be programmed
* to wake-up at a max 127s a head in time. Dividing a 2.4 MHz timer
@@ -230,7 +232,12 @@ static int __init nmdk_timer_init(void __iomem *base, int irq,
pr_err("%s: request_irq() failed\n", "Nomadik Timer Tick");
nmdk_clkevt.cpumask = cpumask_of(0);
nmdk_clkevt.irq = irq;
- clockevents_config_and_register(&nmdk_clkevt, rate, 2, 0xffffffffU);
+ if (rate < 100000)
+ min_ticks = 5;
+ else
+ min_ticks = 2;
+ clockevents_config_and_register(&nmdk_clkevt, rate, min_ticks,
+ 0xffffffffU);

mtu_delay_timer.read_current_timer = &nmdk_timer_read_current_timer;
mtu_delay_timer.freq = rate;
\
 
 \ /
  Last update: 2020-07-23 21:10    [W:0.052 / U:0.248 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site