lkml.org 
[lkml]   [2020]   [Jul]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/2] drm/panel: st7703: Make the sleep exit timing match the spec
Date
The driver seemed to try to make the total cumulative time of all delays
across the whole power up sequence to sum up to 120ms.

The datasheet on the other hand specifies that there needs to be 120ms
delay after the sleep out command, not after reset as the driver
assumes.

Lastly, the delay between init commands and the sleep exit command is
not necessary. (not specified anywhere)

Reported-by: Samuel Holland <samuel@sholland.org>
Signed-off-by: Ondrej Jirman <megous@megous.com>
---
drivers/gpu/drm/panel/panel-sitronix-st7703.c | 7 ++-----
1 file changed, 2 insertions(+), 5 deletions(-)

diff --git a/drivers/gpu/drm/panel/panel-sitronix-st7703.c b/drivers/gpu/drm/panel/panel-sitronix-st7703.c
index 8996ced2b721..45833e6a0f4f 100644
--- a/drivers/gpu/drm/panel/panel-sitronix-st7703.c
+++ b/drivers/gpu/drm/panel/panel-sitronix-st7703.c
@@ -291,7 +291,6 @@ static int xbd599_init_sequence(struct st7703 *ctx)
dsi_dcs_write_seq(dsi, ST7703_CMD_SETBGP,
0x07, /* VREF_SEL = 4.2V */
0x07 /* NVREF_SEL = 4.2V */);
- msleep(20);

dsi_dcs_write_seq(dsi, ST7703_CMD_SETVCOM,
0x2C, /* VCOMDC_F = -0.67V */
@@ -369,16 +368,14 @@ static int st7703_enable(struct drm_panel *panel)
return ret;
}

- msleep(20);
-
ret = mipi_dsi_dcs_exit_sleep_mode(dsi);
if (ret < 0) {
DRM_DEV_ERROR(ctx->dev, "Failed to exit sleep mode: %d\n", ret);
return ret;
}

- /* Panel is operational 120 msec after reset */
- msleep(60);
+ /* Dsiplay on can be issued 120 msec after sleep out */
+ msleep(120);

ret = mipi_dsi_dcs_set_display_on(dsi);
if (ret)
--
2.27.0
\
 
 \ /
  Last update: 2020-07-16 14:39    [W:0.356 / U:0.288 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site