lkml.org 
[lkml]   [2020]   [Jul]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [RFC PATCH v3 16/18] gpu: host1x: mipi: Split tegra_mipi_calibrate and tegra_mipi_wait
From
Date

On 7/16/20 4:01 PM, Dmitry Osipenko wrote:
> 17.07.2020 01:49, Sowjanya Komatineni пишет:
>>> What keeps MIPI clock enabled after completion of the
>>> tegra_mipi_calibrate() invocation?
>> MIPI clock is disabled at end of tegra_mipi_calibrate and is re-enabled
>> during tegra_mipi_wait.
>>
>> I think I should fix this to keep the clock enabled till calibration
>> results are latched.
>>
>> All consumers of tegra_mipi_calibrate() will call tegra_mipi_wait().
>>
>> So will remove clk_disable mipi clk at end of tegra_mipi_calibrate() and
>> clk_enable mipi_clk at beginning of tegra_mipi_wait()
> Isn't it possible to perform the calibration after enabling CSI and
> before of starting the sensor streaming?
Currently this is what I am doing. Triggering calibration start during
CSI receiver being ready and then sensor streaming will happen where
internal MIPI CAL detects for LP -> HS transition and applies results to
pads. So checking for calibration results after sensor stream is enabled

\
 
 \ /
  Last update: 2020-07-17 01:09    [W:0.283 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site