lkml.org 
[lkml]   [2020]   [Jun]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v5 07/11] PCI: qcom: Define some PARF params needed for ipq8064 SoC
From
Date
Hi,

On 6/2/20 2:53 PM, Ansuel Smith wrote:
> Set some specific value for Tx De-Emphasis, Tx Swing and Rx equalization
> needed on some ipq8064 based device (Netgear R7800 for example). Without
> this the system locks on kernel load.
>
> Fixes: 82a823833f4e ("PCI: qcom: Add Qualcomm PCIe controller driver")
> Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
> Cc: stable@vger.kernel.org # v4.5+
> Reviewed-by: Rob Herring <robh@kernel.org>
> ---
> drivers/pci/controller/dwc/pcie-qcom.c | 27 ++++++++++++++++++++++++++
> 1 file changed, 27 insertions(+)
>
> diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
> index f2ea1ab6f584..f5398b0d270c 100644
> --- a/drivers/pci/controller/dwc/pcie-qcom.c
> +++ b/drivers/pci/controller/dwc/pcie-qcom.c
> @@ -46,6 +46,9 @@
>
> #define PCIE20_PARF_PHY_CTRL 0x40
> #define PCIE20_PARF_PHY_REFCLK 0x4C
> +#define PHY_REFCLK_SSP_EN BIT(16)
> +#define PHY_REFCLK_USE_PAD BIT(12)

These two are not used in the patch, please move it in 08/11.

> +
> #define PCIE20_PARF_DBI_BASE_ADDR 0x168
> #define PCIE20_PARF_SLV_ADDR_SPACE_SIZE 0x16C
> #define PCIE20_PARF_MHI_CLOCK_RESET_CTRL 0x174
> @@ -77,6 +80,18 @@
> #define DBI_RO_WR_EN 1
>
> #define PERST_DELAY_US 1000
> +/* PARF registers */
> +#define PCIE20_PARF_PCS_DEEMPH 0x34
> +#define PCS_DEEMPH_TX_DEEMPH_GEN1(x) ((x) << 16)
> +#define PCS_DEEMPH_TX_DEEMPH_GEN2_3_5DB(x) ((x) << 8)
> +#define PCS_DEEMPH_TX_DEEMPH_GEN2_6DB(x) ((x) << 0)
> +
> +#define PCIE20_PARF_PCS_SWING 0x38
> +#define PCS_SWING_TX_SWING_FULL(x) ((x) << 8)
> +#define PCS_SWING_TX_SWING_LOW(x) ((x) << 0)
> +
> +#define PCIE20_PARF_CONFIG_BITS 0x50
> +#define PHY_RX0_EQ(x) ((x) << 24)
>
> #define PCIE20_v3_PARF_SLV_ADDR_SPACE_SIZE 0x358
> #define SLV_ADDR_SPACE_SZ 0x10000000
> @@ -293,6 +308,7 @@ static int qcom_pcie_init_2_1_0(struct qcom_pcie *pcie)
> struct qcom_pcie_resources_2_1_0 *res = &pcie->res.v2_1_0;
> struct dw_pcie *pci = pcie->pci;
> struct device *dev = pci->dev;
> + struct device_node *node = dev->of_node;
> u32 val;
> int ret;
>
> @@ -347,6 +363,17 @@ static int qcom_pcie_init_2_1_0(struct qcom_pcie *pcie)
> val &= ~BIT(0);
> writel(val, pcie->parf + PCIE20_PARF_PHY_CTRL);
>
> + if (of_device_is_compatible(node, "qcom,pcie-ipq8064")) {
> + writel(PCS_DEEMPH_TX_DEEMPH_GEN1(24) |
> + PCS_DEEMPH_TX_DEEMPH_GEN2_3_5DB(24) |
> + PCS_DEEMPH_TX_DEEMPH_GEN2_6DB(34),
> + pcie->parf + PCIE20_PARF_PCS_DEEMPH);
> + writel(PCS_SWING_TX_SWING_FULL(120) |
> + PCS_SWING_TX_SWING_LOW(120),
> + pcie->parf + PCIE20_PARF_PCS_SWING);

Please fix the indentations above.

> + writel(PHY_RX0_EQ(4), pcie->parf + PCIE20_PARF_CONFIG_BITS);
> + }
> +
> /* enable external reference clock */
> val = readl(pcie->parf + PCIE20_PARF_PHY_REFCLK);
> val |= BIT(16);
>

--
regards,
Stan

\
 
 \ /
  Last update: 2020-06-06 18:30    [W:0.063 / U:1.704 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site