lkml.org 
[lkml]   [2020]   [Jun]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[RFC 2/4] regulator: lp87565: dt: remove duplicated section
    Date
    The "Required properties:" section is copied verbatim for each of the two
    supported chips. In preparation to add a new chip variant make it a common
    section and keep the two examples to differentiate between the two chips.

    Signed-off-by: Luca Ceresoli <luca@lucaceresoli.net>
    ---
    .../devicetree/bindings/mfd/lp87565.txt | 21 ++++---------------
    1 file changed, 4 insertions(+), 17 deletions(-)

    diff --git a/Documentation/devicetree/bindings/mfd/lp87565.txt b/Documentation/devicetree/bindings/mfd/lp87565.txt
    index 41671e0dc26b..b75ae23a1ef3 100644
    --- a/Documentation/devicetree/bindings/mfd/lp87565.txt
    +++ b/Documentation/devicetree/bindings/mfd/lp87565.txt
    @@ -1,7 +1,7 @@
    TI LP87565 PMIC MFD driver

    Required properties:
    - - compatible: "ti,lp87565", "ti,lp87565-q1"
    + - compatible: one of "ti,lp87565", "ti,lp87565-q1", "ti,lp87561-q1"
    - reg: I2C slave address.
    - gpio-controller: Marks the device node as a GPIO Controller.
    - #gpio-cells: Should be two. The first cell is the pin number and
    @@ -10,7 +10,8 @@ Required properties:
    - xxx-in-supply: Phandle to parent supply node of each regulator
    populated under regulators node. xxx should match
    the supply_name populated in driver.
    -Example:
    +
    +Example for the TI LP87565-Q1 PMIC (dual 2-phase output configuration):

    lp87565_pmic: pmic@60 {
    compatible = "ti,lp87565-q1";
    @@ -42,21 +43,7 @@ lp87565_pmic: pmic@60 {
    };
    };

    -TI LP87561 PMIC:
    -
    -This is a single output 4-phase regulator configuration
    -
    -Required properties:
    - - compatible: "ti,lp87561-q1"
    - - reg: I2C slave address.
    - - gpio-controller: Marks the device node as a GPIO Controller.
    - - #gpio-cells: Should be two. The first cell is the pin number and
    - the second cell is used to specify flags.
    - See ../gpio/gpio.txt for more information.
    - - xxx-in-supply: Phandle to parent supply node of each regulator
    - populated under regulators node. xxx should match
    - the supply_name populated in driver.
    -Example:
    +Example for the TI LP87561 PMIC (single 4-phase output configuration):

    lp87561_pmic: pmic@62 {
    compatible = "ti,lp87561-q1";
    --
    2.27.0
    \
     
     \ /
      Last update: 2020-06-03 22:04    [W:4.545 / U:0.124 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site