lkml.org 
[lkml]   [2020]   [Jun]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2] usb/phy-generic: Add support for OTG VBUS supply control
From
Date

Met vriendelijke groet / kind regards,

Mike Looijmans
System Expert


TOPIC Embedded Products B.V.
Materiaalweg 4, 5681 RJ Best
The Netherlands

T: +31 (0) 499 33 69 69
E: mike.looijmans@topicproducts.com
W: www.topicproducts.com

Please consider the environment before printing this e-mail
On 29-05-2020 23:08, Rob Herring wrote:
> On Fri, May 29, 2020 at 08:00:45AM +0200, Mike Looijmans wrote:
>> This enables support for VBUS on boards where the power is supplied
>> by a regulator. The regulator is enabled when the USB port enters
>> HOST mode.
>>
>> Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
>> ---
>> v2: Added missing "return 0;" in set_vbus method
>>
>> .../devicetree/bindings/usb/usb-nop-xceiv.txt | 3 ++
>> drivers/usb/phy/phy-generic.c | 46 ++++++++++++++++++-
>> drivers/usb/phy/phy-generic.h | 2 +
>> 3 files changed, 50 insertions(+), 1 deletion(-)
>>
>> diff --git a/Documentation/devicetree/bindings/usb/usb-nop-xceiv.txt b/Documentation/devicetree/bindings/usb/usb-nop-xceiv.txt
>> index 4dc6a8ee3071..775a19fdb613 100644
>> --- a/Documentation/devicetree/bindings/usb/usb-nop-xceiv.txt
>> +++ b/Documentation/devicetree/bindings/usb/usb-nop-xceiv.txt
>> @@ -16,6 +16,9 @@ Optional properties:
>>
>> - vcc-supply: phandle to the regulator that provides power to the PHY.
>>
>> +- vbus-supply: phandle to the regulator that provides the VBUS power for when
>> + the device is in HOST mode.
>> +
> I'm going to say no to expanding this binding...
>
> First, there sure are a lot of controls on a NOP tranceiver.
>
> Second, unless Vbus is supplying the PHY, then this belongs in a
> connector node for which this is already supported.

Clear, I moved the implementation to the DWC3 driver and will submit a
new patch for that.


>
>> - reset-gpios: Should specify the GPIO for reset.
>>
>> - vbus-detect-gpio: should specify the GPIO detecting a VBus insertion


--
Mike Looijmans

\
 
 \ /
  Last update: 2020-06-03 11:01    [W:0.063 / U:0.140 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site