lkml.org 
[lkml]   [2020]   [Jun]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v4 2/2] ARM: imx6plus: enable internal routing of clk_enet_ref where possible
Hi Sven,

On Thu, Jun 25, 2020 at 11:01 AM Sven Van Asbroeck <thesven73@gmail.com> wrote:
>
> On imx6, the ethernet reference clock (clk_enet_ref) can be generated
> by either the imx6, or an external source (e.g. an oscillator or the
> PHY). When generated by the imx6, the clock source (from ANATOP)
> must be routed to the input of clk_enet_ref via two pads on the SoC,
> typically via a dedicated track on the PCB.
>
> On an imx6 plus however, there is a new setting which enables this
> clock to be routed internally on the SoC, from its ANATOP clock
> source, straight to clk_enet_ref, without having to go through
> the SoC pads.
>
> Board designs where the clock is generated by the imx6 should not
> be affected by routing the clock internally. Therefore on a plus,
> we can enable internal routing by default.
>
> Signed-off-by: Sven Van Asbroeck <TheSven73@gmail.com>

I have tested this series on an imx6qp sabresd and unfortunately, it
breaks Ethernet as I can no longer get an IP address from the DHCP
server.

Without this series, IP address can normally be retrieved.

Therefore I suggest to create a device tree property for this feature
and only enable it when such device tree property is present.

\
 
 \ /
  Last update: 2020-06-29 23:45    [W:0.665 / U:0.144 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site