lkml.org 
[lkml]   [2020]   [Jun]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 1/2] dt-bindings: fpga: xilinx-slave-serial: add optional INIT_B GPIO
On Mon, Jun 22, 2020 at 03:37:22PM +0200, Luca Ceresoli wrote:
> The INIT_B is used by the 6 and 7 series to report the programming status,
> providing more control and information about programming errors.
>
> Signed-off-by: Luca Ceresoli <luca@lucaceresoli.net>
>
> ---
>
> Changes in v2:
> - rename init_b-gpios to init-b-gpios (Rob Herring suggested to not use '_'
> in property names)
> ---
> .../devicetree/bindings/fpga/xilinx-slave-serial.txt | 7 ++++++-
> 1 file changed, 6 insertions(+), 1 deletion(-)
>
> diff --git a/Documentation/devicetree/bindings/fpga/xilinx-slave-serial.txt b/Documentation/devicetree/bindings/fpga/xilinx-slave-serial.txt
> index 9f103f3872e8..5ef659c1394d 100644
> --- a/Documentation/devicetree/bindings/fpga/xilinx-slave-serial.txt
> +++ b/Documentation/devicetree/bindings/fpga/xilinx-slave-serial.txt
> @@ -16,6 +16,10 @@ Required properties:
> - prog_b-gpios: config pin (referred to as PROGRAM_B in the manual)
> - done-gpios: config status pin (referred to as DONE in the manual)
>
> +Optional properties:
> +- init-b-gpios: initialization status and configuration error pin
> + (referred to as INIT_B in the manual)
> +
> Example for full FPGA configuration:
>
> fpga-region0 {
> @@ -40,7 +44,8 @@ Example for full FPGA configuration:
> spi-max-frequency = <60000000>;
> spi-cpha;
> reg = <0>;
> - done-gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
> prog_b-gpios = <&gpio0 29 GPIO_ACTIVE_LOW>;
> + init-b-gpios = <&gpio0 28 GPIO_ACTIVE_LOW>;
> + done-gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
> };
> };
> --
> 2.27.0
>

Will apply to for-next,

Thanks!

\
 
 \ /
  Last update: 2020-06-26 23:03    [W:0.035 / U:0.188 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site