lkml.org 
[lkml]   [2020]   [Jun]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 2/2] watchdog: rti: tweak min_hw_heartbeat_ms to match initial allowed window
From
Date
On 25.06.20 10:32, Tero Kristo wrote:
> On 24/06/2020 18:24, Jan Kiszka wrote:
>> On 24.06.20 13:45, Tero Kristo wrote:
>>> If the RTI watchdog has been started by someone (like bootloader) when
>>> the driver probes, we must adjust the initial ping timeout to match the
>>> currently running watchdog window to avoid generating watchdog reset.
>>>
>>> Signed-off-by: Tero Kristo <t-kristo@ti.com>
>>> ---
>>>   drivers/watchdog/rti_wdt.c | 25 +++++++++++++++++++++++++
>>>   1 file changed, 25 insertions(+)
>>>
>>> diff --git a/drivers/watchdog/rti_wdt.c b/drivers/watchdog/rti_wdt.c
>>> index d456dd72d99a..02ea2b2435f5 100644
>>> --- a/drivers/watchdog/rti_wdt.c
>>> +++ b/drivers/watchdog/rti_wdt.c
>>> @@ -55,11 +55,13 @@ static int heartbeat;
>>>    * @base - base io address of WD device
>>>    * @freq - source clock frequency of WDT
>>>    * @wdd  - hold watchdog device as is in WDT core
>>> + * @min_hw_heartbeat_save - save of the min hw heartbeat value
>>>    */
>>>   struct rti_wdt_device {
>>>       void __iomem        *base;
>>>       unsigned long        freq;
>>>       struct watchdog_device    wdd;
>>> +    unsigned int        min_hw_heartbeat_save;
>>>   };
>>>   static int rti_wdt_start(struct watchdog_device *wdd)
>>> @@ -107,6 +109,11 @@ static int rti_wdt_ping(struct watchdog_device
>>> *wdd)
>>>       /* put watchdog in active state */
>>>       writel_relaxed(WDKEY_SEQ1, wdt->base + RTIWDKEY);
>>> +    if (wdt->min_hw_heartbeat_save) {
>>> +        wdd->min_hw_heartbeat_ms = wdt->min_hw_heartbeat_save;
>>> +        wdt->min_hw_heartbeat_save = 0;
>>> +    }
>>> +
>>>       return 0;
>>>   }
>>> @@ -201,6 +208,24 @@ static int rti_wdt_probe(struct platform_device
>>> *pdev)
>>>           goto err_iomap;
>>>       }
>>> +    if (readl(wdt->base + RTIDWDCTRL) == WDENABLE_KEY) {
>>> +        u32 time_left;
>>> +        u32 heartbeat;
>>> +
>>> +        set_bit(WDOG_HW_RUNNING, &wdd->status);
>>> +        time_left = rti_wdt_get_timeleft(wdd);
>>> +        heartbeat = readl(wdt->base + RTIDWDPRLD);
>>> +        heartbeat <<= WDT_PRELOAD_SHIFT;
>>> +        heartbeat /= wdt->freq;
>>> +        if (time_left < heartbeat / 2)
>>> +            wdd->min_hw_heartbeat_ms = 0;
>>> +        else
>>> +            wdd->min_hw_heartbeat_ms =
>>> +                (time_left - heartbeat / 2 + 1) * 1000;
>>> +
>>> +        wdt->min_hw_heartbeat_save = 11 * heartbeat * 1000 / 20;
>>> +    }
>>> +
>>>       ret = watchdog_register_device(wdd);
>>>       if (ret) {
>>>           dev_err(dev, "cannot register watchdog device\n");
>>>
>>
>> This assumes that the bootloader also programmed a 50% window, right?
>> The pending U-Boot patch will do that, but what if that may chance or
>> someone uses a different setup?
>
> Yes, we assume 50%. I think based on the hw design, 50% is the only sane
> value to be used, otherwise you just shrink the open window too much and
> for no apparent reason.

Fine with me, but should we check that assumption when adopting the
watchdog?

Jan

--
Siemens AG, Corporate Technology, CT RDA IOT SES-DE
Corporate Competence Center Embedded Linux

\
 
 \ /
  Last update: 2020-06-25 12:01    [W:0.146 / U:0.324 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site