lkml.org 
[lkml]   [2020]   [Jun]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH net 0/3] net: bcmgenet: use hardware padding of runt frames
Date
Now that scatter-gather and tx-checksumming are enabled by default
it revealed a packet corruption issue that can occur for very short
fragmented packets.

When padding these frames to the minimum length it is possible for
the non-linear (fragment) data to be added to the end of the linear
header in an SKB. Since the number of fragments is read before the
padding and used afterward without reloading, the fragment that
should have been consumed can be tacked on in place of part of the
padding.

The third commit in this set corrects this by removing the software
padding and allowing the hardware to add the pad bytes if necessary.

The first two commits resolve warnings observed by the kbuild test
robot and are included here for simplicity of application.

Doug Berger (3):
net: bcmgenet: re-remove bcmgenet_hfb_add_filter
net: bcmgenet: use __be16 for htons(ETH_P_IP)
net: bcmgenet: use hardware padding of runt frames

drivers/net/ethernet/broadcom/genet/bcmgenet.c | 88 ++------------------------
1 file changed, 5 insertions(+), 83 deletions(-)

--
2.7.4

\
 
 \ /
  Last update: 2020-06-25 03:16    [W:0.042 / U:0.016 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site