lkml.org 
[lkml]   [2020]   [Jun]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/3] ARM: dts: meson8b: ec100: enable the SDHC controller
Date
EC-100 has built-in eMMC flash which is hard-wired to 3.3V VCC (which
means it's limited to high-speed MMC modes). Enable the SDHC controller
to access the contents of the eMMC flash.

Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
---
arch/arm/boot/dts/meson8b-ec100.dts | 25 +++++++++++++++++++++++++
1 file changed, 25 insertions(+)

diff --git a/arch/arm/boot/dts/meson8b-ec100.dts b/arch/arm/boot/dts/meson8b-ec100.dts
index 163a200d5a7b..ed06102a4014 100644
--- a/arch/arm/boot/dts/meson8b-ec100.dts
+++ b/arch/arm/boot/dts/meson8b-ec100.dts
@@ -27,6 +27,11 @@ memory {
reg = <0x40000000 0x40000000>;
};

+ emmc_pwrseq: emmc-pwrseq {
+ compatible = "mmc-pwrseq-emmc";
+ reset-gpios = <&gpio BOOT_9 GPIO_ACTIVE_LOW>;
+ };
+
gpio-keys {
compatible = "gpio-keys-polled";
#address-cells = <1>;
@@ -299,6 +304,26 @@ &saradc {
vref-supply = <&vcc_1v8>;
};

+&sdhc {
+ status = "okay";
+
+ pinctrl-0 = <&sdxc_c_pins>;
+ pinctrl-names = "default";
+
+ bus-width = <8>;
+ max-frequency = <50000000>;
+
+ cap-mmc-highspeed;
+ disable-wp;
+ non-removable;
+ no-sdio;
+
+ mmc-pwrseq = <&emmc_pwrseq>;
+
+ vmmc-supply = <&vcc_3v3>;
+ vqmmc-supply = <&vcc_3v3>;
+};
+
&sdio {
status = "okay";

--
2.27.0
\
 
 \ /
  Last update: 2020-06-20 18:38    [W:0.105 / U:0.036 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site