lkml.org 
[lkml]   [2020]   [Jun]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] ARM: dts: AM33xx-l4: add gpio-ranges
From
Date


On 02/06/2020 16:14, Drew Fustini wrote:
> Add gpio-ranges properties to the gpio controller nodes.
>
> These gpio-ranges were created based on "Table 9-10. CONTROL_MODULE
> REGISTERS" in the "AM335x Technical Reference Manual" [0] and "Table
> 4-2. Pin Attributes" in the "AM335x Sitara Processor datasheet" [1].
> A csv file with this data is available for reference [2].

It will be good if you can explain not only "what" is changed, but
also "why" it's needed in commit message.

>
> [0] https://www.ti.com/lit/ug/spruh73q/spruh73q.pdf
> [1] http://www.ti.com/lit/ds/symlink/am3358.pdf
> [2] https://gist.github.com/pdp7/6ffaddc8867973c1c3e8612cfaf72020
>
> Signed-off-by: Drew Fustini <drew@beagleboard.org>
> ---
> Notes:
> There was previous dicussion relevant to this patch:
> https://lore.kernel.org/linux-gpio/20200525131731.GA948395@x1/
>
> Here is the list I compiled which shows the mapping between a gpioline
> and the pin number including the memory address for the pin control
> register
>
> gpiochip,gpio-line,pinctrl-PIN,pinctrl-address
> 0,0,82,44e10948
> 0,1,83,44e1094c
> 0,2,84,44e10950
> 0,3,85,44e10954
> 0,4,86,44e10958
> 0,5,87,44e1095c

...

> On a BeagleBlack Black board (AM3358) with this patch:
> cat /sys/kernel/debug/pinctrl/44e10800.pinmux-pinctrl-single/gpio-ranges
>
> GPIO ranges handled:
> 0: gpio-0-31 GPIOS [0 - 7] PINS [82 - 89]
> 8: gpio-0-31 GPIOS [8 - 11] PINS [52 - 55]
> 12: gpio-0-31 GPIOS [12 - 15] PINS [94 - 97]
> 16: gpio-0-31 GPIOS [16 - 17] PINS [71 - 72]
> 18: gpio-0-31 GPIOS [18 - 18] PINS [135 - 135]
> 19: gpio-0-31 GPIOS [19 - 20] PINS [108 - 109]
> 21: gpio-0-31 GPIOS [21 - 21] PINS [73 - 73]
> 22: gpio-0-31 GPIOS [22 - 23] PINS [8 - 9]
> 26: gpio-0-31 GPIOS [26 - 27] PINS [10 - 11]
> 28: gpio-0-31 GPIOS [28 - 28] PINS [74 - 74]
> 29: gpio-0-31 GPIOS [29 - 29] PINS [81 - 81]
> 30: gpio-0-31 GPIOS [30 - 31] PINS [28 - 29]
> 0: gpio-32-63 GPIOS [32 - 39] PINS [0 - 7]
> 8: gpio-32-63 GPIOS [40 - 43] PINS [90 - 93]
> 12: gpio-32-63 GPIOS [44 - 59] PINS [12 - 27]
> 28: gpio-32-63 GPIOS [60 - 63] PINS [30 - 33]
> 0: gpio-64-95 GPIOS [64 - 81] PINS [34 - 51]
> 18: gpio-64-95 GPIOS [82 - 85] PINS [77 - 80]
> 22: gpio-64-95 GPIOS [86 - 95] PINS [56 - 65]
> 0: gpio-96-127 GPIOS [96 - 100] PINS [66 - 70]
> 5: gpio-96-127 GPIOS [101 - 102] PINS [98 - 99]
> 7: gpio-96-127 GPIOS [103 - 104] PINS [75 - 76]
> 13: gpio-96-127 GPIOS [109 - 109] PINS [141 - 141]
> 14: gpio-96-127 GPIOS [110 - 117] PINS [100 - 107]
>
> arch/arm/boot/dts/am33xx-l4.dtsi | 24 ++++++++++++++++++++++++
> 1 file changed, 24 insertions(+)
>
> diff --git a/arch/arm/boot/dts/am33xx-l4.dtsi b/arch/arm/boot/dts/am33xx-l4.dtsi
> index 5ed7f3c58c0f..340ea331e54d 100644
> --- a/arch/arm/boot/dts/am33xx-l4.dtsi
> +++ b/arch/arm/boot/dts/am33xx-l4.dtsi
> @@ -151,6 +151,18 @@ SYSC_OMAP2_SOFTRESET |
>
> gpio0: gpio@0 {
> compatible = "ti,omap4-gpio";
> + gpio-ranges = <&am33xx_pinmux 0 82 8>,
> + <&am33xx_pinmux 8 52 4>,
> + <&am33xx_pinmux 12 94 4>,
> + <&am33xx_pinmux 16 71 2>,
> + <&am33xx_pinmux 18 135 1>,
> + <&am33xx_pinmux 19 108 2>,
> + <&am33xx_pinmux 21 73 1>,
> + <&am33xx_pinmux 22 8 2>,
> + <&am33xx_pinmux 26 10 2>,
> + <&am33xx_pinmux 28 74 1>,
> + <&am33xx_pinmux 29 81 1>,
> + <&am33xx_pinmux 30 28 2>;
> gpio-controller;
> #gpio-cells = <2>;
> interrupt-controller;
> @@ -1298,6 +1310,10 @@ SYSC_OMAP2_SOFTRESET |
>
> gpio1: gpio@0 {
> compatible = "ti,omap4-gpio";
> + gpio-ranges = <&am33xx_pinmux 0 0 8>,
> + <&am33xx_pinmux 8 90 4>,
> + <&am33xx_pinmux 12 12 16>,
> + <&am33xx_pinmux 28 30 4>;
> gpio-controller;
> #gpio-cells = <2>;
> interrupt-controller;
> @@ -1700,6 +1716,9 @@ SYSC_OMAP2_SOFTRESET |
>
> gpio2: gpio@0 {
> compatible = "ti,omap4-gpio";
> + gpio-ranges = <&am33xx_pinmux 0 34 18>,
> + <&am33xx_pinmux 18 77 4>,
> + <&am33xx_pinmux 22 56 10>;
> gpio-controller;
> #gpio-cells = <2>;
> interrupt-controller;
> @@ -1733,6 +1752,11 @@ SYSC_OMAP2_SOFTRESET |
>
> gpio3: gpio@0 {
> compatible = "ti,omap4-gpio";
> + gpio-ranges = <&am33xx_pinmux 0 66 5>,
> + <&am33xx_pinmux 5 98 2>,
> + <&am33xx_pinmux 7 75 2>,
> + <&am33xx_pinmux 13 141 1>,
> + <&am33xx_pinmux 14 100 8>;
> gpio-controller;
> #gpio-cells = <2>;
> interrupt-controller;
>

--
Best regards,
grygorii

\
 
 \ /
  Last update: 2020-06-02 15:44    [W:0.083 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site