Messages in this thread Patch in this message | | | From | Heiko Stuebner <> | Subject | [PATCH v4 2/3] dt-bindings: net: ethernet-phy: add enet-phy-clock-out-frequency | Date | Wed, 17 Jun 2020 23:33:25 +0200 |
| |
From: Heiko Stuebner <heiko.stuebner@theobroma-systems.com>
Some ethernet phys have a configurable clock output, so add a generic property to describe its target rate.
Suggested-by: Andrew Lunn <andrew@lunn.ch> Signed-off-by: Heiko Stuebner <heiko.stuebner@theobroma-systems.com> --- Documentation/devicetree/bindings/net/ethernet-phy.yaml | 5 +++++ 1 file changed, 5 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/ethernet-phy.yaml b/Documentation/devicetree/bindings/net/ethernet-phy.yaml index 9b1f1147ca36..4dcf93f1c555 100644 --- a/Documentation/devicetree/bindings/net/ethernet-phy.yaml +++ b/Documentation/devicetree/bindings/net/ethernet-phy.yaml @@ -84,6 +84,11 @@ properties: the turn around line low at end of the control phase of the MDIO transaction. + enet-phy-clock-out-frequency: + $ref: /schemas/types.yaml#definitions/uint32 + description: + Frequency in Hz to set an available clock output to. + enet-phy-lane-swap: $ref: /schemas/types.yaml#definitions/flag description: -- 2.26.2
| |