[lkml]   [2020]   [Jun]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[RFC PATCH v4 0/2] net: dsa: qca8k: Improve SGMII interface handling
Hopefully getting there, thanks for all the review comments.

This 2 patch series migrates the qca8k switch driver over to PHYLINK,
and then adds the SGMII clean-ups (i.e. the missing initialisation) on
top of that as a second patch.

As before, tested with a device where the CPU connection is RGMII (i.e.
the common current use case) + one where the CPU connection is SGMII. I
don't have any devices where the SGMII interface is brought out to
something other than the CPU.

- Enable pcs_poll so we keep phylink updated when doing in-band
- Explicitly check for PHY_INTERFACE_MODE_1000BASEX when setting SGMII
port mode.
- Address Vladimir's review comments
- Move phylink changes to separate patch
- Address rmk review comments
- Switch to phylink
- Avoid need for device tree configuration options

Jonathan McDowell (2):
net: dsa: qca8k: Switch to PHYLINK instead of PHYLIB
net: dsa: qca8k: Improve SGMII interface handling

drivers/net/dsa/qca8k.c | 341 ++++++++++++++++++++++++++++------------
drivers/net/dsa/qca8k.h | 13 ++
2 files changed, 256 insertions(+), 98 deletions(-)


 \ /
  Last update: 2020-06-13 13:33    [W:0.194 / U:1.056 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site