lkml.org 
[lkml]   [2020]   [Jun]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 4/5] dt-bindings: fpga: xilinx-slave-serial: add optional INIT_B GPIO
Date
The INIT_B is used by the 6 and 7 series to report the programming status,
providing more control and information about programming errors.

Signed-off-by: Luca Ceresoli <luca@lucaceresoli.net>
---
.../devicetree/bindings/fpga/xilinx-slave-serial.txt | 7 ++++++-
1 file changed, 6 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/fpga/xilinx-slave-serial.txt b/Documentation/devicetree/bindings/fpga/xilinx-slave-serial.txt
index 9f103f3872e8..a049082e1513 100644
--- a/Documentation/devicetree/bindings/fpga/xilinx-slave-serial.txt
+++ b/Documentation/devicetree/bindings/fpga/xilinx-slave-serial.txt
@@ -16,6 +16,10 @@ Required properties:
- prog_b-gpios: config pin (referred to as PROGRAM_B in the manual)
- done-gpios: config status pin (referred to as DONE in the manual)

+Optional properties:
+- init_b-gpios: initialization status and configuration error pin
+ (referred to as INIT_B in the manual)
+
Example for full FPGA configuration:

fpga-region0 {
@@ -40,7 +44,8 @@ Example for full FPGA configuration:
spi-max-frequency = <60000000>;
spi-cpha;
reg = <0>;
- done-gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
prog_b-gpios = <&gpio0 29 GPIO_ACTIVE_LOW>;
+ init_b-gpios = <&gpio0 28 GPIO_ACTIVE_LOW>;
+ done-gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
};
};
--
2.27.0
\
 
 \ /
  Last update: 2020-06-11 23:12    [W:2.890 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site