Messages in this thread | | | From | Martijn Coenen <> | Date | Mon, 4 May 2020 21:32:47 +0200 | Subject | Re: [PATCH] loop: Call loop_config_discard() only after new config is applied. |
| |
Hi Jens,
Are you ok with this one? One of my later series depends on it, but so far I've kept it separate because it's a bug fix.
Thanks, Martijn
On Sat, Apr 18, 2020 at 5:46 PM Bart Van Assche <bvanassche@acm.org> wrote: > > On 2020-03-31 04:41, Martijn Coenen wrote: > > loop_set_status() calls loop_config_discard() to configure discard for > > the loop device; however, the discard configuration depends on whether > > the loop device uses encryption, and when we call it the encryption > > configuration has not been updated yet. Move the call down so we apply > > the correct discard configuration based on the new configuration. > > Reviewed-by: Bart Van Assche <bvanassche@acm.org>
| |