lkml.org 
[lkml]   [2020]   [May]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v7 3/5] dt-bindings: iio: magnetometer: ak8975: add gpio reset support
On Thu, 28 May 2020 16:59:28 +0200
Jonathan Albrieux <jonathan.albrieux@gmail.com> wrote:

> Add reset-gpio support.
>
> Without reset's deassertion during ak8975_power_on(), driver's probe fails
> on ak8975_who_i_am() while checking for device identity for AK09911 chip.
>
> AK09911 has an active low reset gpio to handle register's reset.
> AK09911 datasheet says that, if not used, reset pin should be connected
> to VID. This patch emulates this situation.
>
> Signed-off-by: Jonathan Albrieux <jonathan.albrieux@gmail.com>
> Reviewed-by: Rob Herring <robh@kernel.org>

Applied to the togreg branch of iio.git and pushed out as testing
for the autobuilders to play with it.

thanks,

Jonathan

> ---
> .../bindings/iio/magnetometer/asahi-kasei,ak8975.yaml | 7 +++++++
> 1 file changed, 7 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/iio/magnetometer/asahi-kasei,ak8975.yaml b/Documentation/devicetree/bindings/iio/magnetometer/asahi-kasei,ak8975.yaml
> index 55b18784e503..e8af53d60759 100644
> --- a/Documentation/devicetree/bindings/iio/magnetometer/asahi-kasei,ak8975.yaml
> +++ b/Documentation/devicetree/bindings/iio/magnetometer/asahi-kasei,ak8975.yaml
> @@ -47,6 +47,11 @@ properties:
> mount-matrix:
> description: an optional 3x3 mounting rotation matrix.
>
> + reset-gpios:
> + description: |
> + an optional pin needed for AK09911 to set the reset state. This should
> + be usually active low
> +
> required:
> - compatible
> - reg
> @@ -54,6 +59,7 @@ required:
> examples:
> - |
> #include <dt-bindings/interrupt-controller/irq.h>
> + #include <dt-bindings/gpio/gpio.h>
> i2c {
> #address-cells = <1>;
> #size-cells = <0>;
> @@ -64,6 +70,7 @@ examples:
> interrupt-parent = <&gpio6>;
> interrupts = <15 IRQ_TYPE_EDGE_RISING>;
> vdd-supply = <&ldo_3v3_gnss>;
> + reset-gpios = <&msmgpio 111 GPIO_ACTIVE_LOW>;
> mount-matrix = "-0.984807753012208", /* x0 */
> "0", /* y0 */
> "-0.173648177666930", /* z0 */

\
 
 \ /
  Last update: 2020-05-31 13:01    [W:0.037 / U:1.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site