lkml.org 
[lkml]   [2020]   [May]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH RFT] ravb: Mask PHY mode to avoid inserting delays twice
On Fri, May 29, 2020 at 02:25:40PM +0200, Geert Uytterhoeven wrote:
> Until recently, the Micrel KSZ9031 PHY driver ignored any PHY mode
> ("RGMII-*ID") settings, but used the hardware defaults, augmented by
> explicit configuration of individual skew values using the "*-skew-ps"
> DT properties. The lack of PHY mode support was compensated by the
> EtherAVB MAC driver, which configures TX and/or RX internal delay
> itself, based on the PHY mode.
>
> However, now the KSZ9031 driver has gained PHY mode support, delays may
> be configured twice, causing regressions. E.g. on the Renesas
> Salvator-X board with R-Car M3-W ES1.0, TX performance dropped from ca.
> 400 Mbps to 0.1-0.3 Mbps, as measured by nuttcp.
>
> As internal delay configuration supported by the KSZ9031 PHY is too
> limited for some use cases, the ability to configure MAC internal delay
> is deemed useful and necessary. Hence a proper fix would involve
> splitting internal delay configuration in two parts, one for the PHY,
> and one for the MAC. However, this would require adding new DT
> properties, thus breaking DTB backwards-compatibility.
>
> Hence fix the regression in a backwards-compatibility way, by letting
> the EtherAVB driver mask the PHY mode when it has inserted a delay, to
> avoid the PHY driver adding a second delay. This also fixes messages
> like:
>
> Micrel KSZ9031 Gigabit PHY e6800000.ethernet-ffffffff:00: *-skew-ps values should be used only with phy-mode = "rgmii"
>
> as the PHY no longer sees the original RGMII-*ID mode.
>
> Solving the issue by splitting configuration in two parts can be handled
> in future patches, and would require retaining a backwards-compatibility
> mode anyway.
>
> Fixes: bcf3440c6dd78bfe ("net: phy: micrel: add phy-mode support for the KSZ9031 PHY")
> Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>

Reviewed-by: Andrew Lunn <andrew@lunn.ch>

Andrew

\
 
 \ /
  Last update: 2020-05-29 16:31    [W:0.189 / U:1.152 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site