lkml.org 
[lkml]   [2020]   [May]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH net-next v4 1/4] dt-bindings: net: Add tx and rx internal delays
On Fri, May 29, 2020 at 1:24 PM Dan Murphy <dmurphy@ti.com> wrote:
>
> Rob
>
> On 5/29/20 1:25 PM, Rob Herring wrote:
> > On Wed, May 27, 2020 at 11:49:31AM -0500, Dan Murphy wrote:
> >> tx-internal-delays and rx-internal-delays are a common setting for RGMII
> >> capable devices.
> >>
> >> These properties are used when the phy-mode or phy-controller is set to
> >> rgmii-id, rgmii-rxid or rgmii-txid. These modes indicate to the
> >> controller that the PHY will add the internal delay for the connection.
> >>
> >> Signed-off-by: Dan Murphy <dmurphy@ti.com>
> >> ---
> >> .../bindings/net/ethernet-controller.yaml | 14 ++++++++++++++
> >> 1 file changed, 14 insertions(+)
> >>
> >> diff --git a/Documentation/devicetree/bindings/net/ethernet-controller.yaml b/Documentation/devicetree/bindings/net/ethernet-controller.yaml
> >> index ac471b60ed6a..70702a4ef5e8 100644
> >> --- a/Documentation/devicetree/bindings/net/ethernet-controller.yaml
> >> +++ b/Documentation/devicetree/bindings/net/ethernet-controller.yaml
> >> @@ -143,6 +143,20 @@ properties:
> >> Specifies the PHY management type. If auto is set and fixed-link
> >> is not specified, it uses MDIO for management.
> >>
> >> + rx-internal-delay-ps:
> >> + $ref: /schemas/types.yaml#definitions/uint32
> >> + description: |
> >> + RGMII Receive PHY Clock Delay defined in pico seconds. This is used for
> >> + PHY's that have configurable RX internal delays. This property is only
> >> + used when the phy-mode or phy-connection-type is rgmii-id or rgmii-rxid.
> > Isn't this a property of the phy (this is the controller schema)? Looks
> > like we have similar properties already and they go in phy nodes. Would
> > be good to have a standard property, but let's be clear where it goes.
> >
> > We need to add '-ps' as a standard unit suffix (in dt-schema) and then a
> > type is not needed here.
>
> This is a PHY specific property.
>
> I will move them.
>
> Dumb question but you can just point me to the manual about how and
> where to add the '-ps' to the dt-schema

Here[1], but looks like I already added it. I'd checked the old kernel
version (property-units.txt) which didn't have it.

Rob

[1] https://github.com/devicetree-org/dt-schema/blob/master/schemas/property-units.yaml#L48

\
 
 \ /
  Last update: 2020-05-29 22:59    [W:0.044 / U:0.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site