Messages in this thread | | | From | Arnd Bergmann <> | Date | Wed, 27 May 2020 16:37:34 +0200 | Subject | Re: [PATCH] mtd: rawnand: arasan: select CONFIG_BCH |
| |
On Wed, May 27, 2020 at 3:53 PM Miquel Raynal <miquel.raynal@bootlin.com> wrote: > > Hi Arnd, > > Arnd Bergmann <arnd@arndb.de> wrote on Wed, 27 May 2020 15:42:03 +0200: > > > Like several other nand flash drivers, this one requires the BCH > > library to be selected from Kconfig. > > Actually most of the time these drivers do not depend on BCH directly. > Here it is a bit particular: the hardware ECC engine logic being > broken, I found a workaround by using BCH's library functions directly > to verify the hardware correctness. > > Anyway, thank you very much for the fix but if I didn't make a mistake > it should have been fixed yesterday night already, so it's probably not > in linux-next yet.
I'm still on yesterday's linux-next, so I was probably just a little late. Thanks for fixing it already.
Arnd
| |