lkml.org 
[lkml]   [2020]   [May]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] check: Add 10bit/slave i2c reg flags support
On Wed, May 27, 2020 at 04:36:56PM +0300, Andy Shevchenko wrote:
> On Wed, May 27, 2020 at 03:25:25PM +0300, Serge Semin wrote:
> > Recently the I2C-controllers slave interface support was added to the
> > kernel I2C subsystem. In this case Linux can be used as, for example,
> > a I2C EEPROM machine. See [1] for details. Other than instantiating
> > the EEPROM-slave device from user-space there is a way to declare the
> > device in dts. In this case firstly the I2C bus controller must support
> > the slave interface. Secondly I2C-slave sub-node of that controller
> > must have "reg"-property with flag I2C_OWN_SLAVE_ADDRESS set (flag is
> > declared in [2]). That flag is declared as (1 << 30), which when set
> > makes dtc unhappy about too big address set for a I2C-slave:
> >
> > Warning (i2c_bus_reg): /example-2/i2c@1120000/eeprom@64: I2C bus unit address format error, expected "40000064"
> > Warning (i2c_bus_reg): /example-2/i2c@1120000/eeprom@64:reg: I2C address must be less than 10-bits, got "0x40000064"
> >
> > Similar problem would have happened if we had set the 10-bit address
> > flag I2C_TEN_BIT_ADDRESS in the "reg"-property.
> >
> > In order to fix the problem we suggest to alter the I2C-bus reg-check
> > algorithm, so one would be aware of the upper bits set. Normally if no
> > flag specified, the 7-bit address is expected in the "reg"-property.
> > If I2C_TEN_BIT_ADDRESS is set, then the 10-bit address check will be
> > performed. The I2C_OWN_SLAVE_ADDRESS flag will be just ignored.
> >
> > [1] kernel/Documentation/i2c/slave-interface.rst
> > [2] kernel/include/dt-bindings/i2c/i2c.h
>
> ...
>

> > + addr = reg & 0x3FFFFFFFU;
> > + if ((reg & (1 << 31)) && addr > 0x3ff)
> > FAIL_PROP(c, dti, node, prop, "I2C address must be less than 10-bits, got \"0x%x\"",
> > - reg);
> > -
> > + addr);
> > + else if (!(reg & (1 << 31)) && addr > 0x7f)
> > + FAIL_PROP(c, dti, node, prop, "I2C address must be less than 7-bits, got \"0x%x\"",
> > + addr);
>
> 1 << 31 is UB.

Good point. Thanks.

-Sergey

>
> --
> With Best Regards,
> Andy Shevchenko
>
>

\
 
 \ /
  Last update: 2020-05-27 16:01    [W:0.159 / U:0.100 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site