Messages in this thread | | | From | Linus Walleij <> | Date | Tue, 26 May 2020 11:22:07 +0200 | Subject | Re: [PATCH v6 3/5] dt-bindings: iio: magnetometer: ak8975: add gpio reset support |
| |
On Mon, May 25, 2020 at 5:13 PM Jonathan Albrieux <jonathan.albrieux@gmail.com> wrote:
> Add reset-gpio support. > > Without reset's deassertion during ak8975_power_on(), driver's probe fails > on ak8975_who_i_am() while checking for device identity for AK09911 chip. > > AK09911 has an active low reset gpio to handle register's reset. > AK09911 datasheet says that, if not used, reset pin should be connected > to VID. This patch emulates this situation. > > Signed-off-by: Jonathan Albrieux <jonathan.albrieux@gmail.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Yours, Linus Walleij
| |