lkml.org 
[lkml]   [2020]   [May]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH net-next v2 0/2] net: enetc: remove bootloader dependency
Date
These patches were picked from the following series:
https://lore.kernel.org/netdev/1567779344-30965-1-git-send-email-claudiu.manoil@nxp.com/
They have never been resent. I've picked them up, addressed Andrews
comments, fixed some more bugs and asked Claudiu if I can keep their SOB
tags; he agreed. I've tested this on our board which happens to have a
bootloader which doesn't do the enetc setup in all cases.

changes since v1:
- mdiobus id is '"imdio-%s", dev_name(dev)' because the plain dev_name()
is used by the emdio.
- use mdiobus_write() instead of imdio->write(imdio, ..), since this is
already a full featured mdiobus
- set phy_mask to ~0 to avoid scanning the bus
- use phy_interface_mode_is_rgmii(phy_mode) to also include the RGMII
modes with pad delays.
- move enetc_imdio_init() to enetc_pf.c, there shouldn't be any other
users, should it?
- renamed serdes to SerDes
- printing the error code of mdiobus_register() in the error path
- call mdiobus_unregister() on _remove()
- call devm_mdiobus_free() if mdiobus_register() fails, since an
error is not fatal

Alex Marginean (1):
net: enetc: Use DT protocol information to set up the ports

Claudiu Manoil (1):
net: enetc: Initialize SerDes for SGMII and SXGMII protocols

.../net/ethernet/freescale/enetc/enetc_hw.h | 17 ++
.../net/ethernet/freescale/enetc/enetc_pf.c | 151 +++++++++++++++---
.../net/ethernet/freescale/enetc/enetc_pf.h | 4 +
3 files changed, 148 insertions(+), 24 deletions(-)

--
2.20.1

\
 
 \ /
  Last update: 2020-05-27 00:52    [W:0.040 / U:0.288 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site