lkml.org 
[lkml]   [2020]   [May]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
SubjectRe: mm: mkfs.ext4 invoked oom-killer on i386 - pagecache_get_page
On Thu 21-05-20 05:24:27, Hugh Dickins wrote:
> On Thu, 21 May 2020, Michal Hocko wrote:
> > On Thu 21-05-20 16:11:11, Naresh Kamboju wrote:
> > > On Thu, 21 May 2020 at 15:25, Michal Hocko <mhocko@kernel.org> wrote:
> > > >
> > > > On Wed 20-05-20 20:09:06, Chris Down wrote:
> > > > > Hi Naresh,
> > > > >
> > > > > Naresh Kamboju writes:
> > > > > > As a part of investigation on this issue LKFT teammate Anders Roxell
> > > > > > git bisected the problem and found bad commit(s) which caused this problem.
> > > > > >
> > > > > > The following two patches have been reverted on next-20200519 and retested the
> > > > > > reproducible steps and confirmed the test case mkfs -t ext4 got PASS.
> > > > > > ( invoked oom-killer is gone now)
> > > > > >
> > > > > > Revert "mm, memcg: avoid stale protection values when cgroup is above
> > > > > > protection"
> > > > > > This reverts commit 23a53e1c02006120f89383270d46cbd040a70bc6.
> > > > > >
> > > > > > Revert "mm, memcg: decouple e{low,min} state mutations from protection
> > > > > > checks"
> > > > > > This reverts commit 7b88906ab7399b58bb088c28befe50bcce076d82.
> > > > >
> > > > > Thanks Anders and Naresh for tracking this down and reverting.
> > > > >
> > > > > I'll take a look tomorrow. I don't see anything immediately obviously wrong
> > > > > in either of those commits from a (very) cursory glance, but they should
> > > > > only be taking effect if protections are set.
> > > >
> > > > Agreed. If memory.{low,min} is not used then the patch should be
> > > > effectively a nop. Btw. do you see the problem when booting with
> > > > cgroup_disable=memory kernel command line parameter?
> > >
> > > With extra kernel command line parameters, cgroup_disable=memory
> > > I have noticed a differ problem now.
> > >
> > > + mkfs -t ext4 /dev/disk/by-id/ata-TOSHIBA_MG04ACA100N_Y8NRK0BPF6XF
> > > mke2fs 1.43.8 (1-Jan-2018)
> > > Creating filesystem with 244190646 4k blocks and 61054976 inodes
> > > Filesystem UUID: 3bb1a285-2cb4-44b4-b6e8-62548f3ac620
> > > Superblock backups stored on blocks:
> > > 32768, 98304, 163840, 229376, 294912, 819200, 884736, 1605632, 2654208,
> > > 4096000, 7962624, 11239424, 20480000, 23887872, 71663616, 78675968,
> > > 102400000, 214990848
> > > Allocating group tables: 0/7453 done
> > > Writing inode tables: 0/7453 done
> > > Creating journal (262144 blocks): [ 35.502102] BUG: kernel NULL
> > > pointer dereference, address: 000000c8
> > > [ 35.508372] #PF: supervisor read access in kernel mode
> > > [ 35.513506] #PF: error_code(0x0000) - not-present page
> > > [ 35.518638] *pde = 00000000
> > > [ 35.521514] Oops: 0000 [#1] SMP
> > > [ 35.524652] CPU: 0 PID: 145 Comm: kswapd0 Not tainted
> > > 5.7.0-rc6-next-20200519+ #1
> > > [ 35.532121] Hardware name: Supermicro SYS-5019S-ML/X11SSH-F, BIOS
> > > 2.2 05/23/2018
> > > [ 35.539507] EIP: mem_cgroup_get_nr_swap_pages+0x28/0x60
> >
> > Could you get faddr2line for this offset?
>
> No need for that, I can help with the "cgroup_disabled=memory" crash:
> I've been happily running with the fixup below, but haven't got to
> send it in yet (and wouldn't normally be reading mail at this time!)
> because of busy chasing a couple of other bugs (not necessarily mm);
> and maybe the fix would be better with explicit mem_cgroup_disabled()
> test, or maybe that should be where cgroup_memory_noswap is decided -
> up to Johannes.

Thanks Hugh. I can see what is the problem now. I was looking at the
Linus' tree and we have a different code there

long nr_swap_pages = get_nr_swap_pages();

if (!do_swap_account || !cgroup_subsys_on_dfl(memory_cgrp_subsys))
return nr_swap_pages;

which would be impossible to crash so I was really wondering what is
going on here. But there are other changes in the mmotm which I haven't
reviewed yet. Looking at the next tree now it is a fallout from "mm:
memcontrol: prepare swap controller setup for integration".

!memcg check slightly more cryptic than an explicit mem_cgroup_disabled
but I would just leave it to Johannes as well.

>
> ---
>
> mm/memcontrol.c | 3 ++-
> 1 file changed, 2 insertions(+), 1 deletion(-)
>
> --- 5.7-rc6-mm1/mm/memcontrol.c 2020-05-20 12:21:56.109693740 -0700
> +++ linux/mm/memcontrol.c 2020-05-20 12:26:15.500478753 -0700
> @@ -6954,7 +6954,8 @@ long mem_cgroup_get_nr_swap_pages(struct
> {
> long nr_swap_pages = get_nr_swap_pages();
>
> - if (cgroup_memory_noswap || !cgroup_subsys_on_dfl(memory_cgrp_subsys))
> + if (!memcg || cgroup_memory_noswap ||
> + !cgroup_subsys_on_dfl(memory_cgrp_subsys))
> return nr_swap_pages;
> for (; memcg != root_mem_cgroup; memcg = parent_mem_cgroup(memcg))
> nr_swap_pages = min_t(long, nr_swap_pages,

--
Michal Hocko
SUSE Labs

\
 
 \ /
  Last update: 2020-05-21 14:45    [W:0.085 / U:0.140 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site