lkml.org 
[lkml]   [2020]   [May]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] lan743x: Added fixed link support
From
Date
Hi Andrew,

thank you for the example, your input got me further. Sorry if my e-mails made the impression that the MAC is sending MDIO on its own. It can issue MDIO but I assume it will do this only on request of the MCU.

I read the data sheets again and found what might have confused us. There is:
a) Auto Negotiation (Phy-Phy)
b) Automatic Speed Detection, ASD (Mac-Phy)
c) Automatic Duplex Detection, ADD (Mac-Phy)

My current hypothesis is: When Phy-Phy auto negotiation is done, the ASD and ADD of the MAC will implicitly catch up the new mode of the Phy on a low level (clocks, pins). A dumb silicon would need the MCU to re-configure the MAC after MDIO told the MCU about a change in the Phy mode. But this ultra smart silicon would neither need MDIO, nor an MCU to understand what’s going on on the busses :)

If this hypothesis is correct, I should change in the driver all comments that mention „auto negoriation“ to „ADD, ASD“, and future readers will not be confused anymore.

Conclusion:
- Maybe I can leave ASD and ADD even active in fixed-link scenarios, when in the device tree an empty fixed-link node is present.
- And I need to disable ASD and/or ADD only if speed and/or duplex is configured inside the fixed-link mode.

I need to verify this hypothesis.

Thank you for reviewing and sharing topics we need to consider,
Roelof

> Am 18.05.2020 um 22:34 schrieb Andrew Lunn <andrew@lunn.ch>:
>
>> I double checked the vendor documentation and according to the data
>> sheet in this device the MAC detects speed and duplex mode. It uses
>> PINs, traces clocks … Also according to an application note of the
>> vendor duplex and speed detection should be enabled in the MAC
>> registers.
>
> In general, the MAC should not perform MDIO requests on the PHY. The
> MAC has no access to the mutex which phylib users. So if the MAC
> directly accesses registers in the PHY, it could do it at the wrong
> time, when the PHY driver is active.
>
> This can be particularly bad when Marvell PHYs are used. They have
> paged registers. One example is the page with the temperature sensor.
> This can be selected due to a read on the hwmon device. If the MAC
> tried to read the speed/duplex which the temperature sensor is
> selected, it would wrongly read the temperature sensor registers, not
> the link state.
>
> There is no need for the MAC to directly access the PHY. It will get
> told what the result of auto-neg is. So please turn this off all the
> time.
>
> Andrew
>

\
 
 \ /
  Last update: 2020-05-19 18:43    [W:1.231 / U:0.552 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site