lkml.org 
[lkml]   [2020]   [May]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 09/19] spi: dw: Parameterize the DMA Rx/Tx burst length
On Mon, May 18, 2020 at 02:01:50PM +0300, Andy Shevchenko wrote:
> On Sat, May 16, 2020 at 05:33:53PM +0300, Serge Semin wrote:
> > On Fri, May 15, 2020 at 05:01:29PM +0300, Andy Shevchenko wrote:
> > > On Fri, May 15, 2020 at 01:47:48PM +0300, Serge Semin wrote:
> > > > It isn't good to have numeric literals in the code especially if there
> > > > are multiple of them and they are related. Moreover in current
> > > > implementation the Tx DMA transfer activation level isn't optimal,
> > > > since it's hardwired to be at 16-32 bytes level, while it's better
> > > > to keep the SPI FIFO buffer as full as possible until all available
> > > > data is submitted. So lets introduce the DMA burst level
> > > > parametrization macros with optimal values - issue Rx transfer if at
> > > > least 16 bytes are available in the buffer and execute Tx transaction
> > > > if at least 16 bytes room is opened in SPI Tx FIFO.
> > >
> > > > - dw_writel(dws, DW_SPI_DMARDLR, 0xf);
> > > > - dw_writel(dws, DW_SPI_DMATDLR, 0x10);
> > > > + dw_writel(dws, DW_SPI_DMARDLR, RX_BURST_LEVEL - 1);
> > > > + dw_writel(dws, DW_SPI_DMATDLR, dws->fifo_len - TX_BURST_LEVEL);
> > >
> > > ...and if FIFO length is less than TX_BURST_LEVEL?
> > >
> > > For the patch that introduces definitions, i.e. keeping the last line here as
> > >
> > > dw_writel(dws, DW_SPI_DMATDLR, TX_BURST_LEVEL);
> > >
> > > I'm good. You may put your tag in that case. For fifo_len case we need to
> > > discuss in separate patch, perhaps.
> >
> > It's fixed in a consequent patch anyway. Though if v3 is required I'll remove
> > this change from here.
>
> I consider that here you might have introduced a regression and actually doing
> two things in one patch. Why not to split?

Theoretically I could, but only for a hardware with FIFO smaller than 16 bytes.
So did I, seeing this module has been dedicated for the Intel Medfield/Elkhart chips
only?

Anyway as I said this change is mostly redundant, since further in this patchset I'll
replace the constants used here with burst length properly calculated based on the
fifo-length and max-burst-length specific to the DMA.

-Sergey

>
> --
> With Best Regards,
> Andy Shevchenko
>
>

\
 
 \ /
  Last update: 2020-05-18 14:42    [W:0.221 / U:0.108 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site