lkml.org 
[lkml]   [2020]   [May]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [Linux-stm32] [PATCH v3 1/2] dt-bindings: serial: Document CTS/RTS gpios in STM32 UART
Date
Hi Geert,


On 5/18/20 9:04 AM, Geert Uytterhoeven wrote:
> Hi Mani,
>
> On Mon, Apr 20, 2020 at 7:02 PM <mani@kernel.org> wrote:
>> From: Manivannan Sadhasivam <mani@kernel.org>
>>
>> Document the use of CTS/RTS gpios for flow control in STM32 UART
>> controller. These properties can be used instead of 'st,hw-flow-ctrl'
>> for making use of any gpio pins for flow control instead of dedicated
>> pins. It should be noted that both CTS/RTS and 'st,hw-flow-ctrl'
>> properties cannot co-exist in a design.
>>
>> Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
>> Signed-off-by: Manivannan Sadhasivam <mani@kernel.org>
>> --- a/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml
>> +++ b/Documentation/devicetree/bindings/serial/st,stm32-uart.yaml
>> @@ -55,6 +61,14 @@ properties:
>> linux,rs485-enabled-at-boot-time: true
>> rs485-rx-during-tx: true
>>
>> +if:
>> + required:
>> + - st,hw-flow-ctrl
> Perhaps "st,hw-flow-ctrl" should be deprecated, in favor of the standard
> "uart-has-rtscts" property?
> Of course the driver needs to gain support for the latter first.

You're fully right, the patch to deprecate "st, hw-flow-ctrl" and
introduce generic "uart-has-rtscts" property in the driver is ready and
will be sent this week on top of Mani patch.


>
>> +then:
>> + properties:
>> + cts-gpios: false
>> + rts-gpios: false
>> +
>> required:
>> - compatible
>> - reg
> Gr{oetje,eeting}s,
>
> Geert
>
\
 
 \ /
  Last update: 2020-05-18 09:27    [W:0.069 / U:0.200 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site