lkml.org 
[lkml]   [2020]   [May]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/4] scsi: hisi_sas: Do not reset phy timer to wait for stray phyup
Date
From: Luo Jiaxing <luojiaxing@huawei.com>

We found out that after phy up, the hardware report another oob interrupt,
but did not follow a phy up interrupt:

oob ready -> phy up -> DEV found -> oob read -> wait phy up -> timeout

We run link reset when wait phy up timeout, and it make a normal disk into
reset processing. So we made some circumvention action in the code, so that
this abnormal oob interrupt will not start the timer to wait for phy up.

Signed-off-by: Luo Jiaxing <luojiaxing@huawei.com>
Signed-off-by: John Garry <john.garry@huawei.com>
---
drivers/scsi/hisi_sas/hisi_sas_main.c | 5 ++++-
1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/scsi/hisi_sas/hisi_sas_main.c b/drivers/scsi/hisi_sas/hisi_sas_main.c
index 9a6deb21fe4d..11caa4b0d797 100644
--- a/drivers/scsi/hisi_sas/hisi_sas_main.c
+++ b/drivers/scsi/hisi_sas/hisi_sas_main.c
@@ -898,8 +898,11 @@ void hisi_sas_phy_oob_ready(struct hisi_hba *hisi_hba, int phy_no)
struct hisi_sas_phy *phy = &hisi_hba->phy[phy_no];
struct device *dev = hisi_hba->dev;

+ dev_dbg(dev, "phy%d OOB ready\n", phy_no);
+ if (phy->phy_attached)
+ return;
+
if (!timer_pending(&phy->timer)) {
- dev_dbg(dev, "phy%d OOB ready\n", phy_no);
phy->timer.expires = jiffies + HISI_SAS_WAIT_PHYUP_TIMEOUT * HZ;
add_timer(&phy->timer);
}
--
2.16.4
\
 
 \ /
  Last update: 2020-05-15 16:18    [W:0.114 / U:0.228 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site