lkml.org 
[lkml]   [2020]   [May]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 04/10] dt-bindings: spi: Add bindings for spi-dw-mchp
Date
This add DT bindings for the Microsemi/Microchip SPI controller used
in various SoC's. It describes the "mscc,ocelot-spi" and
"mscc,jaguar2-spi" bindings.

Reviewed-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
Signed-off-by: Lars Povlsen <lars.povlsen@microchip.com>
---
.../bindings/spi/mscc,ocelot-spi.yaml | 60 +++++++++++++++++++
.../bindings/spi/snps,dw-apb-ssi.txt | 7 +--
MAINTAINERS | 1 +
3 files changed, 63 insertions(+), 5 deletions(-)
create mode 100644 Documentation/devicetree/bindings/spi/mscc,ocelot-spi.yaml

diff --git a/Documentation/devicetree/bindings/spi/mscc,ocelot-spi.yaml b/Documentation/devicetree/bindings/spi/mscc,ocelot-spi.yaml
new file mode 100644
index 0000000000000..a3ac0fa576553
--- /dev/null
+++ b/Documentation/devicetree/bindings/spi/mscc,ocelot-spi.yaml
@@ -0,0 +1,60 @@
+# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: "http://devicetree.org/schemas/spi/mscc,ocelot-spi.yaml#"
+$schema: "http://devicetree.org/meta-schemas/core.yaml#"
+
+title: Microsemi Vcore-III SPI Communication Controller
+
+maintainers:
+ - Alexandre Belloni <alexandre.belloni@bootlin.com>
+ - Lars Povlsen <lars.povlsen@microchip.com>
+
+allOf:
+ - $ref: "spi-controller.yaml#"
+
+description: |
+ The Microsemi Vcore-III SPI controller is a general purpose SPI
+ controller based upon the Designware SPI controller. It uses an 8
+ byte rx/tx fifo.
+
+properties:
+ compatible:
+ enum:
+ - mscc,ocelot-spi
+ - mscc,jaguar2-spi
+
+ interrupts:
+ maxItems: 1
+
+ reg:
+ minItems: 2
+ items:
+ - description: Designware SPI registers
+ - description: CS override registers
+
+ clocks:
+ maxItems: 1
+
+ reg-io-width:
+ description: |
+ The I/O register width (in bytes) implemented by this device.
+ items:
+ enum: [ 2, 4 ]
+ maxItems: 1
+
+required:
+ - compatible
+ - reg
+ - clocks
+
+examples:
+ - |
+ spi0: spi@101000 {
+ compatible = "mscc,ocelot-spi";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ reg = <0x101000 0x100>, <0x3c 0x18>;
+ interrupts = <9>;
+ clocks = <&ahb_clk>;
+ };
diff --git a/Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt b/Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt
index 3ed08ee9feba4..5e1849be7bae5 100644
--- a/Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt
+++ b/Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt
@@ -1,10 +1,8 @@
Synopsys DesignWare AMBA 2.0 Synchronous Serial Interface.

Required properties:
-- compatible : "snps,dw-apb-ssi" or "mscc,<soc>-spi", where soc is "ocelot" or
- "jaguar2", or "amazon,alpine-dw-apb-ssi"
-- reg : The register base for the controller. For "mscc,<soc>-spi", a second
- register set is required (named ICPU_CFG:SPI_MST)
+- compatible : "snps,dw-apb-ssi" or "amazon,alpine-dw-apb-ssi"
+- reg : The register base for the controller.
- interrupts : One interrupt, used by the controller.
- #address-cells : <1>, as required by generic SPI binding.
- #size-cells : <0>, also as required by generic SPI binding.
@@ -38,4 +36,3 @@ Example:
cs-gpios = <&gpio0 13 0>,
<&gpio0 14 0>;
};
-
diff --git a/MAINTAINERS b/MAINTAINERS
index 1db598723a1d8..6472240b8391b 100644
--- a/MAINTAINERS
+++ b/MAINTAINERS
@@ -11231,6 +11231,7 @@ L: linux-mips@vger.kernel.org
S: Supported
F: Documentation/devicetree/bindings/mips/mscc.txt
F: Documentation/devicetree/bindings/power/reset/ocelot-reset.txt
+F: Documentation/devicetree/bindings/spi/mscc,ocelot-spi.yaml
F: arch/mips/boot/dts/mscc/
F: arch/mips/configs/generic/board-ocelot.config
F: arch/mips/generic/board-ocelot.c
--
2.26.2
\
 
 \ /
  Last update: 2020-05-13 16:01    [W:0.262 / U:0.544 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site