lkml.org 
[lkml]   [2020]   [May]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectR: [PATCH v3 09/11] PCI: qcom: add ipq8064 rev2 variant and set tx term offset
Date
> Hi Ansuel,
>
> On 5/1/20 1:06 AM, Ansuel Smith wrote:
> > From: Sham Muthayyan <smuthayy@codeaurora.org>
> >
> > Add tx term offset support to pcie qcom driver need in some revision of
> > the ipq806x SoC.
> > Ipq8064 have tx term offset set to 7.
> > Ipq8064-v2 revision and ipq8065 have the tx term offset set to 0.
> >
> > Signed-off-by: Sham Muthayyan <smuthayy@codeaurora.org>
> > Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
> > ---
> > drivers/pci/controller/dwc/pcie-qcom.c | 15 +++++++++++++++
> > 1 file changed, 15 insertions(+)
> >
> > diff --git a/drivers/pci/controller/dwc/pcie-qcom.c
> b/drivers/pci/controller/dwc/pcie-qcom.c
> > index da8058fd1925..372d2c8508b5 100644
> > --- a/drivers/pci/controller/dwc/pcie-qcom.c
> > +++ b/drivers/pci/controller/dwc/pcie-qcom.c
> > @@ -45,6 +45,9 @@
> > #define PCIE_CAP_CPL_TIMEOUT_DISABLE 0x10
> >
> > #define PCIE20_PARF_PHY_CTRL 0x40
> > +#define PHY_CTRL_PHY_TX0_TERM_OFFSET_MASK GENMASK(12,
> 16)
>
> The mask definition is not correct. Should be GENMASK(20, 16)
>
> > +#define PHY_CTRL_PHY_TX0_TERM_OFFSET(x) ((x) << 16)
> > +
> > #define PCIE20_PARF_PHY_REFCLK 0x4C
> > #define PHY_REFCLK_SSP_EN BIT(16)
> > #define PHY_REFCLK_USE_PAD BIT(12)
> > @@ -118,6 +121,7 @@ struct qcom_pcie_resources_2_1_0 {
> > u32 tx_swing_full;
> > u32 tx_swing_low;
> > u32 rx0_eq;
> > + u8 phy_tx0_term_offset;
> > };
> >
> > struct qcom_pcie_resources_1_0_0 {
> > @@ -318,6 +322,11 @@ static int
> qcom_pcie_get_resources_2_1_0(struct qcom_pcie *pcie)
> > if (IS_ERR(res->ext_reset))
> > return PTR_ERR(res->ext_reset);
> >
> > + if (of_device_is_compatible(dev->of_node, "qcom,pcie-ipq8064"))
> > + res->phy_tx0_term_offset = 7;
>
> Before your change the phy_tx0_term_offser was 0 for apq8064, but here
> you change it to 7, why?
>

apq8064 board should use qcom,pcie-apq8064 right? This should be set to 0
only with pcie-ipq8064 compatible. Tell me if I'm wrong.

> > + else
> > + res->phy_tx0_term_offset = 0;
> > +
> > res->phy_reset = devm_reset_control_get_exclusive(dev, "phy");
> > return PTR_ERR_OR_ZERO(res->phy_reset);
> > }
> > @@ -402,6 +411,11 @@ static int qcom_pcie_init_2_1_0(struct
> qcom_pcie *pcie)
> > /* enable PCIe clocks and resets */
> > qcom_clear_and_set_dword(pcie->parf + PCIE20_PARF_PHY_CTRL,
> BIT(0), 0);
> >
> > + /* set TX termination offset */
> > + qcom_clear_and_set_dword(pcie->parf + PCIE20_PARF_PHY_CTRL,
> > + PHY_CTRL_PHY_TX0_TERM_OFFSET_MASK,
>
> As the mask definition is incorrect you actually clear 12 to 16 bit in
> the register where is another PHY parameter. Is that was intentional?
>

Will check this and the wrong genmask.

> > + PHY_CTRL_PHY_TX0_TERM_OFFSET(res-
> >phy_tx0_term_offset));
> > +
> > writel(PCS_DEEMPH_TX_DEEMPH_GEN1(res->tx_deemph_gen1) |
> > PCS_DEEMPH_TX_DEEMPH_GEN2_3_5DB(res-
> >tx_deemph_gen2_3p5db) |
> > PCS_DEEMPH_TX_DEEMPH_GEN2_6DB(res-
> >tx_deemph_gen2_6db),
> > @@ -1485,6 +1499,7 @@ static int qcom_pcie_probe(struct
> platform_device *pdev)
> > static const struct of_device_id qcom_pcie_match[] = {
> > { .compatible = "qcom,pcie-apq8084", .data = &ops_1_0_0 },
> > { .compatible = "qcom,pcie-ipq8064", .data = &ops_2_1_0 },
> > + { .compatible = "qcom,pcie-ipq8064-v2", .data = &ops_2_1_0 },
> > { .compatible = "qcom,pcie-apq8064", .data = &ops_2_1_0 },
> > { .compatible = "qcom,pcie-msm8996", .data = &ops_2_3_2 },
> > { .compatible = "qcom,pcie-ipq8074", .data = &ops_2_3_3 },
> >
>
> --
> regards,
> Stan

\
 
 \ /
  Last update: 2020-05-13 14:55    [W:0.090 / U:0.412 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site