lkml.org 
[lkml]   [2020]   [May]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH net-next 4/4] net: bcmgenet: add support for ethtool flow control
Date
This commit extends the supported ethtool operations to allow MAC
level flow control to be configured for the bcmgenet driver. It
provides an example of how the new phy_set_pause function and the
phy_validate_pause function can be used to configure the desired
PHY advertising as well as how the phy_get_pause function can be
used for resolving negotiated pause modes which may be overridden
by the MAC.

The ethtool utility can be used to change the configuration to enable
auto-negotiated symmetric and asymmetric modes as well as manually
enabling support for RX and TX Pause frames individually.

Signed-off-by: Doug Berger <opendmb@gmail.com>
---
drivers/net/ethernet/broadcom/genet/bcmgenet.c | 54 ++++++++++++++++++++++++++
drivers/net/ethernet/broadcom/genet/bcmgenet.h | 4 ++
drivers/net/ethernet/broadcom/genet/bcmmii.c | 38 ++++++++++++++----
3 files changed, 89 insertions(+), 7 deletions(-)

diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.c b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
index ff31da0ed846..c0e22da7ac53 100644
--- a/drivers/net/ethernet/broadcom/genet/bcmgenet.c
+++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
@@ -1017,6 +1017,53 @@ static int bcmgenet_set_coalesce(struct net_device *dev,
return 0;
}

+static void bcmgenet_get_pauseparam(struct net_device *dev,
+ struct ethtool_pauseparam *epause)
+{
+ struct bcmgenet_priv *priv;
+ u32 umac_cmd;
+
+ priv = netdev_priv(dev);
+
+ epause->autoneg = priv->autoneg_pause;
+
+ if (priv->old_link > 0) {
+ /* report active state when link is up */
+ umac_cmd = bcmgenet_umac_readl(priv, UMAC_CMD);
+ epause->tx_pause = !(umac_cmd & CMD_TX_PAUSE_IGNORE);
+ epause->rx_pause = !(umac_cmd & CMD_RX_PAUSE_IGNORE);
+ } else {
+ /* otherwise report stored settings */
+ epause->tx_pause = priv->tx_pause;
+ epause->rx_pause = priv->rx_pause;
+ }
+}
+
+static int bcmgenet_set_pauseparam(struct net_device *dev,
+ struct ethtool_pauseparam *epause)
+{
+ struct bcmgenet_priv *priv = netdev_priv(dev);
+
+ if (!dev->phydev)
+ return -ENODEV;
+
+ if (!phy_validate_pause(dev->phydev, epause))
+ return -EINVAL;
+
+ priv->autoneg_pause = !!epause->autoneg;
+ priv->tx_pause = !!epause->tx_pause;
+ priv->rx_pause = !!epause->rx_pause;
+
+ /* Restart the PHY */
+ if (netif_running(dev))
+ priv->old_link = -1;
+
+ phy_set_pause(dev->phydev, priv->rx_pause, priv->tx_pause,
+ priv->autoneg_pause);
+
+ return 0;
+}
+
/* standard ethtool support functions. */
enum bcmgenet_stat_type {
BCMGENET_STAT_NETDEV = -1,
@@ -1670,6 +1717,8 @@ static const struct ethtool_ops bcmgenet_ethtool_ops = {
.get_ts_info = ethtool_op_get_ts_info,
.get_rxnfc = bcmgenet_get_rxnfc,
.set_rxnfc = bcmgenet_set_rxnfc,
+ .get_pauseparam = bcmgenet_get_pauseparam,
+ .set_pauseparam = bcmgenet_set_pauseparam,
};

/* Power down the unimac, based on mode. */
@@ -4018,6 +4067,11 @@ static int bcmgenet_probe(struct platform_device *pdev)

spin_lock_init(&priv->lock);

+ /* Set default pause parameters */
+ priv->autoneg_pause = 1;
+ priv->tx_pause = 1;
+ priv->rx_pause = 1;
+
SET_NETDEV_DEV(dev, &pdev->dev);
dev_set_drvdata(&pdev->dev, dev);
dev->watchdog_timeo = 2 * HZ;
diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.h b/drivers/net/ethernet/broadcom/genet/bcmgenet.h
index a12cb59298f4..e44830b3aa4a 100644
--- a/drivers/net/ethernet/broadcom/genet/bcmgenet.h
+++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.h
@@ -683,6 +683,10 @@ struct bcmgenet_priv {
/* HW descriptors/checksum variables */
bool crc_fwd_en;

+ unsigned autoneg_pause:1;
+ unsigned tx_pause:1;
+ unsigned rx_pause:1;
+
u32 dma_max_burst_length;

u32 msg_enable;
diff --git a/drivers/net/ethernet/broadcom/genet/bcmmii.c b/drivers/net/ethernet/broadcom/genet/bcmmii.c
index 511d553a4d11..788da1ecea0c 100644
--- a/drivers/net/ethernet/broadcom/genet/bcmmii.c
+++ b/drivers/net/ethernet/broadcom/genet/bcmmii.c
@@ -25,6 +25,21 @@

#include "bcmgenet.h"

+static u32 _flow_control_autoneg(struct phy_device *phydev)
+{
+ bool tx_pause, rx_pause;
+ u32 cmd_bits = 0;
+
+ phy_get_pause(phydev, &tx_pause, &rx_pause);
+
+ if (!tx_pause)
+ cmd_bits |= CMD_TX_PAUSE_IGNORE;
+ if (!rx_pause)
+ cmd_bits |= CMD_RX_PAUSE_IGNORE;
+
+ return cmd_bits;
+}
+
/* setup netdev link state when PHY link status change and
* update UMAC and RGMII block when link up
*/
@@ -71,12 +86,20 @@ void bcmgenet_mii_setup(struct net_device *dev)
cmd_bits <<= CMD_SPEED_SHIFT;

/* duplex */
- if (phydev->duplex != DUPLEX_FULL)
- cmd_bits |= CMD_HD_EN;
-
- /* pause capability */
- if (!phydev->pause)
- cmd_bits |= CMD_RX_PAUSE_IGNORE | CMD_TX_PAUSE_IGNORE;
+ if (phydev->duplex != DUPLEX_FULL) {
+ cmd_bits |= CMD_HD_EN |
+ CMD_RX_PAUSE_IGNORE | CMD_TX_PAUSE_IGNORE;
+ } else {
+ /* pause capability defaults to Symmetric */
+ if (phydev->autoneg && priv->autoneg_pause)
+ cmd_bits |= _flow_control_autoneg(phydev);
+
+ /* Manual override */
+ if (!priv->rx_pause)
+ cmd_bits |= CMD_RX_PAUSE_IGNORE;
+ if (!priv->tx_pause)
+ cmd_bits |= CMD_TX_PAUSE_IGNORE;
+ }

/*
* Program UMAC and RGMII block based on established
@@ -350,7 +373,8 @@ int bcmgenet_mii_probe(struct net_device *dev)
return ret;
}

- linkmode_copy(phydev->advertising, phydev->supported);
+ phy_support_asym_pause(phydev);
+ phy_advertise_supported(phydev);

/* The internal PHY has its link interrupts routed to the
* Ethernet MAC ISRs. On GENETv5 there is a hardware issue
--
2.7.4
\
 
 \ /
  Last update: 2020-05-12 02:25    [W:0.132 / U:0.432 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site