lkml.org 
[lkml]   [2020]   [May]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v0 1/1] spi: spi-rockchip: add support for spi slave_mode
Hi Chris,

On Sat, 9 May 2020 at 02:10, Chris Ruehl <chris.ruehl@gtsys.com.hk> wrote:
>
> Hi Emil,
>
> thanks for the review and your comments
>
> On 8/5/2020 9:13 pm, Emil Renner Berthing wrote:
> > Hi Chris,
> >
> > On Fri, 8 May 2020 at 10:47, Chris Ruehl <chris.ruehl@gtsys.com.hk> wrote:
> >> This patch aim to add spi slave mode support to the rockchip driver.
> >> Fix the wrong usage of num_cs set fix to ROCKCHIP_SPI_MAX_CS_NUM,
> >> instead use max_native_cs flag to set the limit of native chip-select.
> >> Enable use_gpio_descriptors to have cs_gpiod for gpio based chip-selects.
> >>
> >> Signed-off-by: Chris Ruehl <chris.ruehl@gtsys.com.hk>
> >> ---
> >> drivers/spi/spi-rockchip.c | 46 +++++++++++++++++++++++++++++++++-----
> >> 1 file changed, 41 insertions(+), 5 deletions(-)
> >>
> >> diff --git a/drivers/spi/spi-rockchip.c b/drivers/spi/spi-rockchip.c
> >> index 70ef63e0b6b8..9c1ff52c0f85 100644
> >> --- a/drivers/spi/spi-rockchip.c
> >> +++ b/drivers/spi/spi-rockchip.c
> >> @@ -183,6 +183,9 @@ struct rockchip_spi {
> >> u8 rsd;
> >>
> >> bool cs_asserted[ROCKCHIP_SPI_MAX_CS_NUM];
> >> +
> >> + bool slave_mode;
> >> + bool slave_abort;
> >> };
> >>
> >> static inline void spi_enable_chip(struct rockchip_spi *rs, bool enable)
> >> @@ -359,7 +362,7 @@ static void rockchip_spi_dma_rxcb(void *data)
> >> struct rockchip_spi *rs = spi_master_get_devdata(master);
> >> int state = atomic_fetch_andnot(RXDMA, &rs->state);
> >>
> >> - if (state & TXDMA)
> >> + if (state & TXDMA && !rs->slave_abort)
> >> return;
> >>
> >> spi_enable_chip(rs, false);
> >> @@ -372,7 +375,7 @@ static void rockchip_spi_dma_txcb(void *data)
> >> struct rockchip_spi *rs = spi_master_get_devdata(master);
> >> int state = atomic_fetch_andnot(TXDMA, &rs->state);
> >>
> >> - if (state & RXDMA)
> >> + if (state & RXDMA && !rs->slave_abort)
> >> return;
> >>
> >> /* Wait until the FIFO data completely. */
> >> @@ -466,6 +469,10 @@ static void rockchip_spi_config(struct rockchip_spi *rs,
> >> u32 cr1;
> >> u32 dmacr = 0;
> >>
> >> + if (rs->slavemode)
> >> + cr0 |= CR0_OPM_SLAVE << CR0_OPM_OFFSET;
> >> + rs->slave_abort = false;
> >> +
> >> cr0 |= rs->rsd << CR0_RSD_OFFSET;
> >> cr0 |= (spi->mode & 0x3U) << CR0_SCPH_OFFSET;
> >> if (spi->mode & SPI_LSB_FIRST)
> >> @@ -535,6 +542,16 @@ static size_t rockchip_spi_max_transfer_size(struct spi_device *spi)
> >> return ROCKCHIP_SPI_MAX_TRANLEN;
> >> }
> >>
> >> +static int rockchip_spi_slave_abort(struct spi_master *master)
> >> +{
> >> + struct rockchip_spi *rs = spi_master_get_devdata(master);
> >> +
> >> + rs->slave_abort = true;
> >> + complete(master);
> >> +
> >> + return 0;
> >> +}
> >> +
> >> static int rockchip_spi_transfer_one(
> >> struct spi_master *master,
> >> struct spi_device *spi,
> >> @@ -589,14 +606,25 @@ static int rockchip_spi_probe(struct platform_device *pdev)
> >> struct spi_master *master;
> >> struct resource *mem;
> >> u32 rsd_nsecs;
> >> + bool slave_mode;
> >> + u32 num_cs = 1;
> >> +
> >> + slave_mode = of_property_read_bool(np, "spi-slave");
> >> +
> >> + if (slave_mode)
> >> + master = spi_alloc_slave(&pdev->dev,
> >> + sizeof(struct rockchip_spi));
> >> + else
> >> + master = spi_alloc_master(&pdev->dev,
> >> + sizeof(struct rockchip_spi));
> >>
> >> - master = spi_alloc_master(&pdev->dev, sizeof(struct rockchip_spi));
> >> if (!master)
> >> return -ENOMEM;
> >>
> >> platform_set_drvdata(pdev, master);
> >>
> >> rs = spi_master_get_devdata(master);
> >> + rs->slave_mode = slave_mode;
> > This entry doesn't seem to be read from any of your code, and even it
> > it was, the same information is available in master->slave, so I don't
> > see why you need it in the rockchip_spi struct.
> I haven't see the slave flag in the spi_controller struct, I will store the
> information
> there.
> >
> > Also spi_master is just #defined to spi_controller in spi.h, so maybe
> > consider changing all 'struct spi_master *master' to 'struct
> > spi_controller *ctrl' now that the driver supports both modes.
> Can do, but I think that is better to have a separate patch for it,
> make it easier for review.

Yes, you should probably do something like

patch 1/3: change struct spi_master *master to struct spi_controller *ctrl
patch 2/3: add slave slave mode
patch 3/3: use num-cs property for ctrl->num_chipselect

> >
> >> /* Get basic io resource and map it */
> >> mem = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> >> @@ -676,7 +704,16 @@ static int rockchip_spi_probe(struct platform_device *pdev)
> >> master->auto_runtime_pm = true;
> >> master->bus_num = pdev->id;
> >> master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_LOOP | SPI_LSB_FIRST;
> >> - master->num_chipselect = ROCKCHIP_SPI_MAX_CS_NUM;
> >> + if (slave_mode) {
> >> + master->mode_bits |= SPI_NO_CS;
> >> + master->slave_abort = rockchip_spi_slave_abort;
> >> + } else {
> >> + of_property_read_u32(np, "num-cs", &num_cs);
> >> + master->num_chipselect = num_cs;
> > If you do something like this you won't need the temporary num_cs variable:
> >
> > if (of_property_read_u32(np, "num-cs", &master->num_chipselect))
> > master->num_chipselect = 1;
> Like it , can see clearly the fallback to a default if num-cs isn't set in the
> dts.
> >
> > Also it seems like you're changing the default from
> > ROCKCHIP_SPI_MAX_CS_NUM to 1 if there is no num-cs property. Did you
> > check that all boards either have the num-cs property defined or only
> > needs num_chipselect = 1?
> Only spi0 of the rockchip has a 2nd native chip select, all others a single only
> therefore I find it less evil to use 1 vs. ROCKCHIP_SPI_MAX_CS_NUM
>
> >> + master->use_gpio_descriptors = true;
> >> + master->max_native_cs = ROCKCHIP_SPI_MAX_CS_NUM;
> >> + master->flags = SPI_MASTER_GPIO_SS;
> >> + }
> >> master->dev.of_node = pdev->dev.of_node;
> >> master->bits_per_word_mask = SPI_BPW_MASK(16) | SPI_BPW_MASK(8) | SPI_BPW_MASK(4);
> >> master->min_speed_hz = rs->freq / BAUDR_SCKDV_MAX;
> >> @@ -686,7 +723,6 @@ static int rockchip_spi_probe(struct platform_device *pdev)
> >> master->transfer_one = rockchip_spi_transfer_one;
> >> master->max_transfer_size = rockchip_spi_max_transfer_size;
> >> master->handle_err = rockchip_spi_handle_err;
> >> - master->flags = SPI_MASTER_GPIO_SS;
> >>
> >> master->dma_tx = dma_request_chan(rs->dev, "tx");
> >> if (IS_ERR(master->dma_tx)) {
> >> --
> >> 2.20.1
> >>
> >>
> >> _______________________________________________
> >> Linux-rockchip mailing list
> >> Linux-rockchip@lists.infradead.org
> >> http://lists.infradead.org/mailman/listinfo/linux-rockchip
>
> --
> GTSYS Limited RFID Technology
> 9/F, Unit E, R07, Kwai Shing Industrial Building Phase 2,
> 42-46 Tai Lin Pai Road, Kwai Chung, N.T., Hong Kong
> Tel (852) 9079 9521
>
> Disclaimer: https://www.gtsys.com.hk/email/classified.html
>

\
 
 \ /
  Last update: 2020-05-10 18:16    [W:0.068 / U:0.060 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site