lkml.org 
[lkml]   [2020]   [Apr]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v3 1/1] scsi: pm: Balance pm_only counter of request queue during system resume
From
Date
On 2020-04-29 22:40, Can Guo wrote:
> On 2020-04-30 13:08, Bart Van Assche wrote:
>> On 2020-04-29 21:10, Can Guo wrote:
>>> During system resume, scsi_resume_device() decreases a request queue's
>>> pm_only counter if the scsi device was quiesced before. But after that,
>>> if the scsi device's RPM status is RPM_SUSPENDED, the pm_only counter is
>>> still held (non-zero). Current scsi resume hook only sets the RPM status
>>> of the scsi device and its request queue to RPM_ACTIVE, but leaves the
>>> pm_only counter unchanged. This may make the request queue's pm_only
>>> counter remain non-zero after resume hook returns, hence those who are
>>> waiting on the mq_freeze_wq would never be woken up. Fix this by calling
>>> blk_post_runtime_resume() if pm_only is non-zero to balance the pm_only
>>> counter which is held by the scsi device's RPM ops.
>>
>> How was this issue discovered? How has this patch been tested?
>
> As the issue was found after system resumes, so the issue was discovered
> during system suspend/resume test, and it is very easy to be replicated.
> After system resumes, if this issue hits some scsi devices, all bios sent
> to their request queues are blocked, which may cause a system hang if the
> scsi devices are vital to system functionality.
>
> To make sure the patch work well, we have tested system suspend/resume
> and made sure no system hang happen due to request queues got blocked
> by imbalanced pm_only counter.

Thanks, that's very interesting information. My concern with this patch
is that the power management code is not the only caller of
blk_set_pm_only() / blk_clear_pm_only(). E.g. the SCSI SPI code also
calls scsi_device_quiesce() and scsi_device_resume(). These last
functions call blk_set_pm_only() and blk_clear_pm_only(). More calls of
scsi_device_quiesce() and scsi_device_resume() might be added in the future.

Has it been considered to test directly whether a SCSI device has been
runtime suspended instead of relying on blk_queue_pm_only()? How about
using pm_runtime_status_suspended() or adding a function in
block/blk-pm.h that checks whether q->rpm_status == RPM_SUSPENDED?

Thanks,

Bart.

\
 
 \ /
  Last update: 2020-04-30 22:34    [W:0.106 / U:0.200 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site